COMPLIANCE INFO 2016 - 2017 - Laserfiche WebLink

Home Browse Search

r � .1 B-5) The main fitting body (Item A) should be installed to the outside first. Then apply adhesive as shown (Fig. 135). FhFuz[gaz M, The Adhesive Injection Port on the fitting body must be at the 12 -o -Clock or North Position. B.6) Apply adhesive to the Main Body's outer surface (Fig. 135) 360° where shown. mAY - 3 2017 -. - !T Adhesive Injection Port X) B.7) After applying adhesive to all contact areas (Fig. 1135) Apply the flange over the fitting and to the wall. 13.8) Apply the Bravo Clamp immediately as shown in Fig. B8. Install clamp shown to the body roughly 1/4" from the face and tighten. Then hand -tighten each bolt so it is snug. Apply a 1/4 - 1/2 turn to each bolt evenly until the clamp starts to slide away from the wall and flush with the face of the fitting. B.9) Apply a generous bead of adhesive as shown. (Fig. 139). B. 1 0) Glue all penetration fittings and allow to cure following the pipe manufacturers adhesive instructions. 7 ii -F -Series -1 X -SS -11 A Adhesive Item B Adhesive OUTSIDE Install Main body to outside of sum Install the loo e Flange and apply adhesive to areas shown and use gloved finger to run a generous bead along joint. B.7) After applying adhesive to all contact areas (Fig. 1135) Apply the flange over the fitting and to the wall. 13.8) Apply the Bravo Clamp immediately as shown in Fig. B8. Install clamp shown to the body roughly 1/4" from the face and tighten. Then hand -tighten each bolt so it is snug. Apply a 1/4 - 1/2 turn to each bolt evenly until the clamp starts to slide away from the wall and flush with the face of the fitting. B.9) Apply a generous bead of adhesive as shown. (Fig. 139). B. 1 0) Glue all penetration fittings and allow to cure following the pipe manufacturers adhesive instructions. 7 ii -F -Series -1 X -SS -11 A