Laserfiche WebLink
Case shown with <br />End Panel Removed <br />For Illustrative <br />Purposes Only <br />8 <br />INSTALLATION, CONT’D.: CASE STARTUP / CONFIRMING EVAPORATOR COIL FAN DISCHARGE <br />7. Turn On Power To Case <br /> <br />Caution! Before turning on main power switch, confirm that <br />no obstructions to fan blades or other moving parts exist. <br />Lift up deck pans to check for obstructions. <br />Power cord [located at case rear] should already be plugged <br />into outlet. See INSTALLATION section of this manual. <br />If there is no power cord, case is to be field-wired at rear. <br />See FIELD ACCESS [CASE REAR] section in this manual <br />for specifics on field wiring. <br />Access main power switch by removing front grille. <br />Main power switch is located on main electrical box, below <br />controller. See illustration at top-right. <br /> <br />8. Confirm Evaporator Coil Fan Discharge <br /> <br />When main power switch is turned on, refrigeration assembly <br />will energize (see CASE START-UP & REFRIGERATION <br />ASSEMBLY ACCESS section). <br />Evaporator coil fans should turn on. <br />From inside of case, check for discharge air from front baffle <br />(shown below), to confirm that fans are functioning properly. <br />Caution! Evaporator fans have protective fan guard to <br />prevent injury caused by spinning fan blades. Do not <br />remove fan guard! <br />Check that cold air is beginning to circulate. <br />When the case is in a start up mode or has been idle for a <br />long period of time, a 75 minute run time is required to fully <br />achieve set point temperatures. <br />See below illustration. <br />Note <br />Illustrations shown may not <br />reflect every feature or option <br />of your particular case. <br />Front Baffle <br />Deck Pan <br />Carel® Temperature <br />Controller <br />Main Power <br />Switch <br />Evaporator Fans <br />[Shown With <br />Fan Guard <br />Attached