COMPLIANCE INFO 2002 - 2006 - Laserfiche WebLink

Home Browse Search

Page 4 of 7 6. PIPING SUMP TESTING Test Method Developed By: ❑Sump Manufacturer X Industry Standard ❑Professional Engineer ❑Other(Spec) Test Method Used: ❑Pressure O Vacuum X Hydrostatic 0 Other(Spec) Test Equipment Used: Incon TS-STS Equipment Resolution: Sump#P.P.S. Sump#R.P.S. Sump# Sump# Sump Diameter: 42" 42" Sump Depth: 62" 64" Sump Material: Fiberglass Fiberglass Height from Tank Top to Top of 12" 12" Highest Piping Penetration: Height from Tank Top to Lowest 2299 2399 Electrical Penetration: Condition of sump prior to testing: Clean Clean Portion of Sump Tested' Bottom Bottom Does turbine shut down when sump sensor detects liquid(both X Yes ❑ No ❑NA X Yes 0 No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA product and water)?* Turbine shutdown response time 2 Seconds 2 seconds Is system programmed for fail-safe X Yes ONo ❑NA X Yes ❑ No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No [INA shutdown?* Was fail-safe verified to be operational?* fail-safe XYes ❑No ❑NA X Yes ❑ No ❑NA ❑Yes O No ❑NA X Yes ❑No O NA Wait time between applying pressure/vacuum/water and starting 15 minutes 15 minutes test: Test Start Time: 9:24 am 9:24 am Initial Reading(Rj): 1.7398" 0.7114" Test End Time: 9:40 am 9:40 am Final Reading(RF): 1.7397" 0.7097" Test Duration: 16 minutes 16 minutes Change in Reading(RF-RI): .0001" loss .0017" loss Pass/Fail Threshold or Criteria: Loss<.002"=pass Loss<.002"=pass Test Result: X Pass ❑Fail X Pass ❑Fail ❑ Pass 0 Fail ❑ Pass ❑Fail Was sensor removed for testing? XYes ❑No ❑NA X Yes ❑No ❑NA ❑Yes ❑No O NA ❑Yes ❑No ❑NA Was sensor properly replaced and verified functional after testing? XYes ❑No ❑NA XYes ❑No ❑NA ❑Yes ❑No ❑NA El Yes ❑No ❑NA Comments— (include information on repairs made prior to testing, and recommended follow-up for failed tests) Unable to briny water over the DiDinfl Denetrations due to lack of test boots. ' If the entire depth of the sump is not tested,specify how much was tested. If the answer to any of the questions indicated with an asterisk(*)is"NO"or"NA",the entire sump must be tested. (See SWRCB LG-160)