Laserfiche WebLink
SB Series Pellethane Split Repair Boots installation Instructions <br /> I,or Replacement Repairs) <br /> STEP 1 Identify the damaged boot and select the proper Blueline Repair <br /> Boot based upon the number of studs and the pipe OD. (See 2006 <br /> Catalog,Section 10 and Appendix 1) <br /> m® <br /> STEP 2 Remove band clamps from old fitting. Remove the nuts from the <br /> scuds and store for future use.Remove old fitting. The old fitting <br /> u ill need to be cut off. Take care not to damage the secondary <br /> pipe <br /> m <br /> STEP 3 Install all Pellethane split components onto the pipe carefully. All <br /> Pellethane pieces must be rebonded back together with Blue Seal <br /> Glue.This is done by ensuring that the surfaces are clean and dry. <br /> Apply a liberal bead of Blue Seal and hold the scam closed <br /> securely until it is fused. It's helpful to use the clamps to loosely <br /> hold the boot closed during curing. Bonded connections should <br /> hold themselves closed within five minutes if there are no stresses <br /> on them.The Blue Seal glue will be fully cured in 40 minutes. <br /> STEP 4 Once all components are bonded, apply a liberal bead of either <br /> Parasealant 626, or Bostik 1100FS to the underside of the seal. <br /> This will make the seal with the sump wall. Insert poly ring into <br /> the gasket and position it onto the studs and up against the sump ° <br /> wall. <br /> k7 <br /> STEP 5 Reinstall nuts and tighten them in a star pattern. <br /> 4 <br /> BLUELINE <br /> • • 2001 • [8661310-3848 <br />