Laserfiche WebLink
Cherokee Service Center A91701.01 <br /> July 10, 1996 Page 2 <br /> PROPOSED WORK SCOPE <br /> Task 1 - Additional Sampling - Eastern Dispenser Island <br /> An additional soil sample will be collected at the approximate location of soil boring HA-10 <br /> drilled during our investigation in December, 1995. The SJCPHS will be notified of the date <br /> and time that the sample will be collected. The sample will be collected at deeper than <br /> approximately 6 feet below site grade (BSG), or at a reasonable and appropriate depth specified <br /> by the SJCPHS-ESD representative. Soil sampling, decontamination of equipment, handling of <br /> soil cuttings, sample handling, and field screening with a photoionization detector (PID) will be <br /> performed in accordance with our "Standard Operating Procedures" contained in Appendix "A" <br /> of the Amended Work Plan. <br /> The sampling depth will be attained by boring with a hand auger soil boring device until native <br /> soils are encountered (below any fill material). The soil sample will be collected from the native <br /> soils by driving a soil sampler, equipped with stainless-steel or brass sample retention sleeve, <br /> into undisturbed soil at the bottom of the augered hole. The soil sample and cuttings will be <br /> screened in the field with a PID. The soil boring will be abandoned by backfilling with a neat <br /> cement slurry. The slurry will be poured into the boring slowly to preclude the potential for <br /> bridging and formation of voids. <br /> Task 2 - Analytical Testing of Soil Sample <br /> The soil sample will be chemically analyzed in the Twining's analytical laboratory for the <br /> following analytes: <br /> Total petroleum hydrocarbons -gasoline range constituents (TPH-G) and total petroleum <br /> hydrocarbons - diesel range constituents (TPH-D) using the gas chromatography/flame <br /> ionization (GC/FID) method as recommended in the California State Water Resources <br /> Control Board's L=Idng Underground Storage Tank MFT) Field Manual. <br /> Benzene, toluene, ethylbenzene, and xylenes(BTEX)and methyl tert-butyl ether(MTBE) <br /> using the United States Environmental Protection Agency (U. S. EPA) Method 8020. <br />