COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

EHLeve' LogCAPelDendastemed by Others. The Level Detector and switches shall be checketl for pro er o erehon Others Exterior Paintin CHANGE-Rev.1 SP Logistics ! Ex ense Tank Liners/Collin r,h,,,b, PEX REVE% P5-STDO1-E LINR gnficant coating falure over 30 percent on the tank external surface with several areas where the paint off and there is active surface corrosion. The coating has chipped off mostly around the manway and pitting was noted in these areas during this inspection The first course of the tank shelf and nozzles sted,cleaned and recoaled.The remainder of the tank shall be spot recoated as required rface corrasion on the manway and reinforcing pad where the coating has failed but no pitting These areas shall be cleaned and recoated. I The shell nozzle(su fon)is in fair condition with no significant internal corrosion,but there is surface cones on around the external nozzle where the coating has peeled off.These areas shall be cleaned and recoated The coaling on the fixed root is in poor condition with several areas where the casting has chipped off and exposed the bare metal. These areas shall be cleaned and recoaled. All exterior areas where the repairs were made and the coaling has fated shall be removed and recoated Coating shall be applied to BP painting speciflcalion APL-SP-102,system 1 or 2, Damagedifailed areas of the tank coating shall be recoaled Foundation Re airs 8P Lo istics Fxpense foundation CAPE% - REVE% PS•STD01-E TK FNOTN There Is no Murtdad'on seal between Me external twtlom edge pmJecaen and the concrete pad(oundanon,which allows water to run under the tank. Apply an approved sealant to the gap between the chime and the concrete Painter'@ Hrtch _ BP Loglstics Ca ital Tank Roof—_Stationary CAPEX PS STO01-C.TK SROR _REVE% The fared cone roof has one painter's hitch that is attached to a c rcular sfeel plate that is bolted to the roof plate The existing painter's hitch,circular steel plate and attachment bolls shall be removed and replaced with two(2 approved hitches as shown below. One(1)new hitch shall be installed in the center of the mot and the other new hitch shall ba inshund anprommately 3'in a radial direction away from the center of the lank roof The existing bolt holes shall be plug welded or patched at the discretion or the contractor Patches shall be a 114' thick minimum 6'diameter A-36 plate seal welded all around with a full and complete 3/16"fillet weld. A standard API 650 Figure 5-22,4"painters hitch shall be installed near the center of the cone roof The painters hitch shah :ye installed with l�—apn`veidgtlet veelld-s.utilizurigg{E7018 electrodes.