WORK PLANS - Laserfiche WebLink

Home Browse Search

i 16 August 2011 AGE-NC Project No . 97-0301 Page 4 of 11 1 ,2-DCA) to monitor hydrocarbon destruction efficiency; during this time , DPE operational parameters including depth to water measurements , soil-vapor concentrations , DPE flow, DPE vacuum and DPE total gallons (totalizer) will be monitored on a daily basis to gauge the optimal DPE performance and optimal destruction rate of recovered hydrocarbon vapors . Following the DPE start-up period , influent and effluent DPE samples will be collected on a monthly basis and the DPE operational parameters will be monitored on a weekly basis (at a minimum) to monitor cleanup progress . 2 . 9 . REPORT PREPARATION Following the above referenced field activities (i . e, monitoring well installations , ground water monitoring event, dual phase extraction remediation system installation) , a reportwill be prepared detailing the procedures and findings. The report will include a description of work performed and the results of the soil and groundwater sampling and analysis; conclusions and recommendations will also be included , if applicable . The report will be in a format acceptable to the EHD , and will be reviewed and signed by a California Professional Geologist. 3 .0 . FIELD PROCEDURES The DPE remediation system will be located in the southwest corner of the site near well MW-4 (Figure 3), which will allow the current tenants at the site to conduct their day to day business with minimum interference from the operation of the remediation system . The entire DPE remediation system will be secured by a chain-linked , gated enclosure approximately 15 feet wide , 25 feet long and seven feet high . Electricity is readily available to the site and a dedicated electrical meter will be installed by representatives of Pacific Gas and Electrical ( PG&E) that will connect and power the DPE system . All field procedures will be overseen by an AGE representative under the supervision of a California Professional Geologist . Procedures for well installation , development, remediat7on weldmonitoring , well nstallation , DPE—installation;underground-piping - installation , start-up period , DPE operation and maintenance procedures are described below. 3 . 1 . PERMITTING An application for a site-specific permit will be submitted to the San Joaquin Valley Air Pollution Control District (SJVAPCD) prior to initiation of the remediation project . In ' addition , proper permits will be obtained from the Cityof Stockton Municipal Utilities District that meets all waste discharge requirements into the sanitary sewer and for all necessary i Advanced GeoEnvironmental, Inc.