Laserfiche WebLink
1 <br /> S_ Five <br /> Once the fiberglass sump base is in place, use the remaining adhesive to <br /> apply a minimum of one layer of 4"wide fiberglass matting around the entire <br /> interior circumference of the joint. <br /> Step Six <br /> 1 Allow a minimum of four hoursforthe adhesiveto harden completely. Do not <br /> move or impact the joint during this hardening process. Cure time is <br /> 10 <br /> dependent on ambient temperatures. External heat is recommended to <br /> shorten cure cycles when ambient temperature is below 70°F. However,the <br /> F or bubbling will occur, causing a poor <br /> temperature should not exceed 400° <br /> .......... ' bond. After a heat assist is used, bonded sections should not be disturbed <br /> he adhesive has returned to room temperature. <br /> or placed into service until t <br /> G <br /> 7 6 5 <br /> Step Seven <br /> Once the fiberglass sump base has been bonded in place, follow the <br /> appropriate TCI Sump/Riser Installation Instructions for mounting the riser <br /> and lid. <br /> NOTAL <br /> CONTAINMENT <br /> LN C <br /> 306 Commerce Drive • Exton, PA 19341 • 215-524-9274 <br /> Designs and specifications are subject to change without notice. REV0493 <br /> 0 TO 1993, U.S. &Worldwide Patents <br />