Laserfiche WebLink
Step Five 1 <br /> o G Place the nut on the inside of the ri;l ith the angled side facing the <br /> \ o riser and the recessed end facing up <br /> .gine upthe holes onthe nutwhh <br /> o the two holes previously drilled in the riser. Insert the two stainless <br /> o steel bolts from the outside of the riser,through the riser and through <br /> the plastic nut.Then,tighten the stainless steel nuts onto the bolts(5 <br /> inch pounds torque). Note:Do not sink the heads of the screws more <br /> than 1/32" into the plastic. Repeat Steps Three to Five with the <br /> remaining nuts. <br /> Step Six <br /> Place the O-ring over the top of the riser as shown. <br /> Step Seven <br /> Drill through the lid in the center of each dimple with a 3/8" drill bit. <br /> Then, place the lid on top of the riser and O-ring, aligning the 3/8" <br /> holes over the plastic nuts installed on the riser. <br /> O <br /> Step Eight <br /> T Place the flat gasket over the threaded stud on the knob and then <br /> I thread the knob down through the lid into the nut. Repeat this step <br /> �— with all remaining knobs. Torque the knobs to 10 inch pounds. <br /> Step Nine <br /> For added protection, run a bead of Bostik FS1100 between the <br /> sump and riser after installation. <br /> E <br /> 0 0 <br /> TOTAL <br /> CONTAINMENT <br /> FAX 215-524-7530 REV1192 <br /> 306 COMMERCE DRIVE • EXTON, PA 19341 • 215-524-9274 • <br />