COMPLIANCE INFO_2005 - 2012 - Laserfiche WebLink

Home Browse Search

MONIT*ING SYSTEM CERTIFWATION CERTIFICATION / TEST DATE: August 1, 2006 Al. FACILITY A2. OWNER Name 99 Shell Name Angle Enterprises Address 7700 Moreland Court,Stockton, CA 95212 Address 35584 Conavan Lane, Fremont, CA 94536 Phone# 209-939-1906 Phone# 510-552-4822 Contact Balaji Angle Contact Balaji Angle D. RESULTS OF TESTING / SERVICING Make / Model of Monitoring System: Veeder-Root TLS-350 Software Version Installed: 324.02 Complete the following checklist: ■ Yes ❑ No* Is the audible alarm operational? ■ Yes ❑ No* Is the visual alarm operational? ■ Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? ■ Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station,Is all communications equipment(e.g.modems) ■ N/A operational? ■ Yes ❑ No* I For pressurized piping systems,does the turbine automatically shut down If the piping secondary containment ❑ N/A monitoring system detects a leak,fails to operate,or Is electrically disconnected? If yes:which sensors Initiate positive shutdown? (check all that apply) ■ Sump/Trench sensors; ■ Dispenser Containment Sensors. ■ Yes ❑ No* Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.no ■ N/A mechanical overfill prevention valve is installed),Is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger? °% ❑ Yes* ■ No Was any monitoring equipment replaced? If yes,Identify specific sensors,probes,or other equipment replaced and list the manufacturer name and model for all replacement parts In Section E,below. ■ Yes* ❑ No Was any liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ■ Product; ■ Water. If yes,describe causes in Section E,below. ■ Yes ❑ No* Was monitoring system set-up reviewed to Insure proper settings? Attach set-up reports,N applicable. ■ Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? * In Section E below,describe how and when these deficiencies were or will be corrected. E. COMMENTS Fill sumps, STP sumps and UDC's are all double wall and brine filled. All have Veeder-Root model 0794380-322 sensors. The vent transition box is double wall and brine filled with Veeder-Root model 0794380-208 and 0794380-322 sensors. The continuos vacuum on the secondary lines is monitored with Veeder-Root model 0330020-408 smart sensors. Diesel and 91 tanks are a split tank with a single annular. Found diesel leak in dispenser 5-6. Found liquid in 87 STP sump. 2006 Walton Engineering,Inc. Page 2 of 3