Laserfiche WebLink
P-C-111C <br /> f. Determine loss by evaporation to be replaced by make-up liquid <br /> by the following procedure: <br /> (1) Bring tank with cleaner to operating temperature. Mark <br /> original tank level permanently. <br /> (2) Maintain at operating temperature for 4 hours . <br /> (3) Determine number of gallons of make-up liquid needed to re- <br /> store tank to marked level . <br /> (4) Divide this number by 4, to determine number of gallons of <br /> make-up liquid to be added per every hour of operation. <br /> 6. Warning! Harmful or fatal if swallowed. Avoid contact with skin, <br /> eyes and clothing. In case of contact, immediately flush with plenty of water <br /> for at least 15 minutes; for eyes, obtain medical attention. Avoid prolonged <br /> breathing of vapor. Use with adequate ventilation. The use of gloves and <br /> protective equipment is recommended. <br /> 7. Ingredients. This carbon removing compound contains - (The manufac- <br /> turer shall list ingredients. Glycol ethers" may be used instead of listing <br /> individual ingredients of 'the glycol ether type.) <br /> 8. The compound is formulated to clean soiled pistons in 16 hours at <br /> room temperature or in 4 hours at 130°F. <br /> For type II compounds: <br /> DIRECTIONS FOR USE <br /> 1. This compound is ready for use. Do not add solvent or water. <br /> 2. Fill cleaning bath to a reference mark with fresh compound. <br /> 3. Before soaking item in compound, remove all loose grease, dirtand <br /> oil with a degreasing solvent (kerosene, Stoddard solvent, etc.). <br /> Place <br /> objects to be cleaned in a wire basket or hang them by a wire so as to be <br /> off the bottom and completely immersed. <br /> 4. Soak for 2 to 16 hours as necessary to remove or loosen carbon. <br /> Raise items slowly, allowing for drainage. Rinse with water, kerosene or <br /> solvent. To effectively remove carbon, brush with a stiff bristle brush <br /> under running hot water. <br /> 5. Make-up liquid and drag out replacement: <br /> a. Fill tank with fresh cleaner and mark level permanently after <br /> reaching operating temperature (do not use at temperatures above 130°F.) . <br /> 23 <br />