Laserfiche WebLink
r <br /> 1 C. Second Coat Application: After embedding and covering coat has hardened, apply second <br /> 2 coat, using topping compound, feathered approximately 2 inches beyond edges of first <br /> r 3 coat. Spot fastener heads with similar coat. Allow to dry. <br /> 4 <br /> 5 D. Third Coat Application: After second coat is dry, sand lightly. Apply a thin finishing coat <br /> a of topping compound to joints and fastener heads. Feather joint edges at least 2 inches <br /> ' 7 beyond second coat. Sand lightly when dry. <br /> a <br /> 9 E. Apply joint treatment to butt and end joints, feathering approximately 18 inches. <br /> 10 <br /> 11 F. Finishing Inside Corners: Fold tape along center crease. Butter both sides of corner with <br /> 12 joint compound and apply tape. Apply second and third coats. <br /> 13 <br /> r 14 3.13 FINISHING BEADS AND TRIMS <br /> 15 <br /> 16 A. Apply joint compound to all bead and trim and properly feather out from high point to plane <br /> 17 of surface. Allow to harden. <br /> to <br /> 19 B. Apply second coat in same manner as first coat, extending topping compound slightly <br /> r 20 beyond onto face of panel. <br /> 21 <br /> 22 C. Apply finish coat to all bead and trim, extending topping compound slightly beyond the <br /> 23 second coat and properly feathering from high point to plane of surface. Sand finish coat <br /> ' 24 as necessary when dry to provide a flat, smooth surface ready for decoration. <br /> 25 <br /> 26 3.14 SURFACE FINISHING AND TEXTURING <br /> r 27 <br /> za A. All joint treatment and fastener finishing must be thoroughly dry before surface finishing and <br /> 29 texturing is started. <br /> 30 <br /> ' 31 B. The entire wall or ceiling surface should be lightly sanded or sponged as required to assure <br /> 32 a smooth and even surface. See Section 09900 and 09901 for paint requirements. <br /> 33 <br /> 34 C. Texturing: "Spatter knockdown" texture pattern. <br /> 35 <br /> 36 3.15 PATCHING <br /> ' 37 <br /> 38 Correct all surface damage and defects, leaving work smooth, uniform, without observable <br /> 39 blemishes which will show through the surface finish, and ready for painting or wall <br /> 40 covering. <br /> 41 <br /> 42 <br /> 43 <br /> ' 44 <br /> 45 <br /> 46 END OF SECTION <br /> 1 <br /> r <br /> r GYPSUM DRYWALL CONSTRUCTION <br /> 050694 09251-5 <br /> 1 <br />