Laserfiche WebLink
PART 3 - EXECUTION <br /> 3.1 WORKMANSHIP <br /> A. All work in this Section shall conform to the codes and standards outlined herein. <br /> ' B. The Contractor shall employ personnel that are skilled and experienced in the installation and <br /> connection of all elements, equipment, devices, instruments, accessories, and assemblies. All <br /> installation labor shall be performed by qualified personnel who have had experience on <br /> similar projects. Provide first class workmanship for all installations. <br /> C. Ensure that all equipment and materials fit properly in their installations. <br /> D. Perform any required work to correct improper installations at no additional expense to the <br /> Owner. <br /> ' E. The Owner reserves the right to halt any work that is found to be substandard or being <br /> installed by unqualified personnel. <br /> 3.2 CONSTRUCTION METHODS, GENERAL <br /> IA. All wiring shall be neatly bundled and laced with plastic tie-wraps, anchored in place by screw <br /> attached retainer. Where space is available, such as in electrical cabinets, all wiring shall be <br /> run in slotted plastic xireways or channels with dust covers. Wireways or channels shall be <br /> sized such that the wire fill does not exceed 60%. Wires carrying 100 volts and above shall <br /> be physically separated from lower voltage wiring by using separate bundles or wireways with <br /> sufficient distance to minimize the introduction of noise, crossing only at 90 degree angles. <br /> Tie-wraps shall be T&B TY-RAF's or approved equal. <br /> ' B. Where wiring crosses hinged surfaces, provide an"U" shaped hinge loop protected by plastic <br /> spiral wrap. The hinge loop shall be of sufficient length to permit opening and closing the <br /> door without stressing any of the terminations or connections. <br /> ' C. Wireways, retainers, and other devices shall be screw mounted with round-head 316 stainless <br /> steel screws. Glue or sticky back attachment of any type or style shall not be used. <br /> D. All devices and wiring shall be permanently labeled and secured in accordance with <br /> subsections 2.2 NAMEPLATES AND TAGS and 2.3 WIRE. <br /> ' E. All components associated with a particular compartment's or enclosure's function shall be <br /> mounted in that compartment or enclosure. <br /> ELECTRICAL <br /> 16000 - 45 <br />