Laserfiche WebLink
Figure C-2 Figure D-2 <br /> Sand Mating Area Open Top Model <br /> 4"Past Each Joint <br /> .. ,.. <br /> 4 Watertight Lid <br /> 3' Layers of Glass <br /> with Cuffs v <br /> Resin 3"Past Each Enclosure Top <br /> Joint(Kit LK) <br /> i <br /> 4" 3 Round Body Extension <br /> (Trim From Bottom for <br /> Field Adjustment) <br /> Field Bonded , <br /> Collar or Body Adhesive Joint <br /> Polygon or Round <br /> Sump Body <br /> D. • • e <br /> e e Field Bonded <br /> Adhesive Joint <br /> Collar <br /> Failure to properly test and seal joints may result in r`..,. <br /> product loss,environmental damage,explosion,or fire. <br /> • e <br /> Figure D-1 Figure E-1 <br /> Watertight Lid Model Flat Bottom Sump <br /> Watertight Lid Watertight Lid <br /> Enclosure Top <br /> Enclosure Top__-F <br /> Optional Round <br /> Body Extension _ <br /> (Trim from bottom Optional Round Sump_ <br /> for field adjustment) Body Extension <br /> Field Bonded <br /> Adhesive Joint Field Bonded, <br /> Adhesive Joint <br /> Polygon or Round <br /> Sump Body Polygon Sump Body <br /> Field Bonded Sump Bottom\ <br /> AdhesiveJoint <br /> Tank Mounted Fitting <br /> Collar w/Sump Adapter <br /> Tank Wall _\_ Tank Wall- <br /> Sumps may be round, polygon,or a combination <br /> • All joints must be sealed with adhesive or layup of round and polygon, depending upon the sump <br /> material to provide a watertight sump. height required. <br /> • Always vent sumps, which can be accomplished with • All joints must be sealed with adhesive or layup <br /> double wall piping, running an independent sump material to provide a watertight sump. <br /> vent, or a vent fitting in the lid. • Always vent sumps. May be accomplished with <br /> • Keep the sump lid, o-ring and o-ring groove free from double wall piping, running an independent sump <br /> contaminates. vent, or a vent fitting in the lid. <br /> • When installing lid, apply additional lubricant as • Install tank fitting adapters per the manufacturers <br /> needed. installation instructions into the tank. Prepare sump <br /> • Step on lid perimeter until lid pops into place and is bottom to accept tank fitting adapters. <br /> properly seated. <br /> NON-WATERTIGHT SUMP: The top and lid joints will <br /> be loose fit connections and will not be watertight. <br /> 4 <br />