Laserfiche WebLink
If the testing method does not test the entire sump, specify how much of the sump was tested Methods not testing the <br />entire sump should only be used if the monitoring system provides fail-safe shutdown. (See SWRCB LG -160) <br />'With the submersible pump running, place the sensor in product (discriminating sensors should be placed in water). The time <br />between placing the sensor in product and the turbine shutting down is the response time. This should be done if the secondary <br />containment method used does not test the entire volume of the sump. <br />* This information is not needed if the entire sump is tested. <br />Revision: <br />SWRCB, January 2002 <br />Page 4 of 7 <br />6. PIPING SUMIP TESTING <br />Test Method Developed By: <br />Sump Manufacturer ® Industry Standard OProfessional Engineer <br />13 Oder (Spedy) <br />Test Method Uses: <br />®Pressure ®Vacuum ®Hydrostatic <br />Other (Speci& <br />Test Equipment Used: incon is-sts <br />Equipment Resolution: 0.001" <br />Sum # 1 Sum # Sum # Sum # <br />Sump Diameter. <br />36" <br />Sump Depth: <br />45" <br />Sump Material: <br />fiberglass <br />Height from Tank Top to Highest <br />21" <br />Piping Penetration: <br />Height from Tank Top to Lowest <br />17" <br />Electrical Penetration: <br />Condition of sump prior to testing: <br />good <br />Portion of Sump Tested' <br />23" 8 2014 <br />Does turbine shut down when <br />sump sensor detects either product <br />na ENVIRON MENTAL HEALTF <br />or water? <br />Turbine shutdown response time t# <br />na <br />Is system programmed for fail-safe <br />shutdown?* <br />na <br />Was fail-safe verified to be <br />operational?* <br />na <br />Wait time between applying <br />pressure/vacuum/water and starting <br />30 min. <br />test: <br />Test Start Time: <br />12:1.6 pm/12:34 pm <br />Initial Reading ): <br />3.761711/3.7038" <br />Test End Time: <br />12:31 pm/12:49 pm <br />Final Reading (RO: <br />3.7619"/3.7048" <br />Test Duration: <br />2x1.5 min. <br />Change in Reading (Rg-RI): <br />+0.0010" <br />Pass/Fail Threshold or Criteria: <br />0.002" <br />yes <br />Was sensor removed for testing? <br />Was sensor properly replaced after <br />testing? <br />yes <br />Comments - (include information on repairs made prior to testing, and recommended follow-up for failed tests) <br />there was epee r <br />test becausse the wire 31a Mcoved after 2nd Wt was started and test hqd tarted. <br />If the testing method does not test the entire sump, specify how much of the sump was tested Methods not testing the <br />entire sump should only be used if the monitoring system provides fail-safe shutdown. (See SWRCB LG -160) <br />'With the submersible pump running, place the sensor in product (discriminating sensors should be placed in water). The time <br />between placing the sensor in product and the turbine shutting down is the response time. This should be done if the secondary <br />containment method used does not test the entire volume of the sump. <br />* This information is not needed if the entire sump is tested. <br />Revision: <br />