COMPLIANCE INFO_2012-2017 - Laserfiche WebLink

Home Browse Search

' If the testing method does not test the entire depth of the UDC, specify how much of the UDC was tested. Methods not testing the entire UDC should only be used if the monitoring system provides fail-safe shutdown. (See SVrRCB LG -160) 2 With the submersible pump running, place the sensor in product (discriminating sensors should be placed in water). The time between placing the sensor in product and the turbine shutting down is the response time. This should be done if the secondary containment method used does not test the entire volume of the UDC. * This information is not needed if the entire sump is tested. Revision: SVi RCB, January 2002 Page S of 7 7. UNDER -DISPENSER CONTAINMENT (UDC) TESTING Test Method Developed By: ®UDC Manufacturer ®Industry Standard ®Professional Engineer 130ther (SpeCJ1') Test Method Uses: 13Pressure ®Vacuum Hydrostatic other eci` ) Test Equipment Used: Equipment Resolution: UDC # UDC # 1W# UDC # UDC Manufacturer: UDC Material: UDC D th: Height from UDC Bottom to Top of Highest PipjU Penetration: Height from UDC Bottom to Lowest Electrical Penetration: Condition of UDC prior to testing: dD Portion of UDC Tested Does turbine shut down when UDC sensor detects either S 2014 product or water?* Turbine shutdown response IDEPARTMENT timet* Is system programmed for fail- safe shutdown?* Was fail-safe verified to be operational?* Wait time between applying pressure/vacuum/water and starting test: Test Start Time: Initial Reading Test End Time: Emal Readin ): Test Duration: Change in Readin Pass/Fail Threshold or Criteria: Was sensor removed for testing? Was sensor properly replaced and verified functional after testing? Comments - (include information on repairs made prior to testing, and recommended follow-up far failed tests) This site is not equipped with any dispensers. ' If the testing method does not test the entire depth of the UDC, specify how much of the UDC was tested. Methods not testing the entire UDC should only be used if the monitoring system provides fail-safe shutdown. (See SVrRCB LG -160) 2 With the submersible pump running, place the sensor in product (discriminating sensors should be placed in water). The time between placing the sensor in product and the turbine shutting down is the response time. This should be done if the secondary containment method used does not test the entire volume of the UDC. * This information is not needed if the entire sump is tested. Revision: