ARCHIVED REPORTS_2006_1 - Laserfiche WebLink

Home Browse Search

Sec. 10-1, Construction Details Std. Spec.Sec 80 Special Page 1 of 3 SECTION 80. FENCING PART 1 - GENERAL ' Unless otherwise specified, all fencing work shall be in accordance with Standard Detail A-86 and Standard Specifications Section 80. ' PART 2 - MATERIALS ' All gate frame pipes and gate posts shall be galvanized schedule 40 unless otherwise specified. ' 2.01 DRIVE GATE A. Corners of the gate frame shall be welded. Welds shall be smooth, sound and shall develop the strength of the connected member. B. Welded corners of the gate frame shall be painted with two (2) coats of rust inhibitive SILVER paint. C. Gate frame panels shall be cross trussed with galvanized adjustable truss rods having diameters of not less than 3/8-inch. D. Chain link fabric per Standard Specifications Section 80-4.01 B shall be attached to the gate frame by the use of galvanized stretch bars and 7 gauge galvanized tie wires. E. Suitable tension connectors shall be spaced at approximately one foot intervals. F. Drive gates shall be hung with two (2) galvanized steel adjustable arm hinges. ' G. A combination steel or malleable iron catch and locking attachment shall be provided with the gate. H. Post caps shall be schedule 40 galvanized post caps. I. Gates shall swing as directed by the Engineer. All drive gates shall open and close freely without any obstruction. Any drive gates not installed to the satisfaction of the Engineer will be required to be re-installed at no additional cost to the County 2.02 WALK GATE ' A. Corners of the gate frame shall be welded. Welds shall be smooth and shall develop the strength of the connected member. Welded corners of the gate frame shall be painted with two (2) coats of rust inhibitive SILVER paint. The gate frame shall be braced with ' 3/8-inch diameter truss rod. Chain link fabric per Standard Specifications Section 80-4.01 B shall be attached to the gate frame by the use of galvanized stretch bars and galvanized tie wires. The gates shall be hung by two (2) adjustable arm malleable iron ' hinges. A combination steel or malleable iron catch and locking attachment shall be provided with the gate. ' B. The height of walk gates vary. Walk gates in alignment with barbed wire fence shall be 4-feet high. Walk gates in alignment with existing chain link fence shall be fabricated and installed to the height of the existing chain link fence.