ARCHIVED REPORTS_2012 - Laserfiche WebLink

Home Browse Search

n 1.09Q UALITY CONTROL A. Use adequate numbers of skilled workman who are trained and experienced in the necessary crafts and who are familiar with the specified requirements and the methods needed for performance of the work of this Section. PART 2 - PRODUCTS 2.01 PIPE A. All HDPE pipe and fittings shall comply with ASTM F714 -06a. B. All HDPE pipe and fittings shall be comprised of PE 3608 polyethylene that has a grade of PE 36 with a minimum cell classification of Type III, PE 345464C, as defined in ASTM D3350. C. HDPE pipe shall be homogeneous throughout, uniform in color, and free of cracks, holes (except where specified), foreign materials, blisters, or deleterious faults. 2.02 MANUFACTURER SOURCE QUALITY CONTROL A. The delivered pipe shall be HDPE and shall meet the requirements presented in Article 2.01 and the Standard Dimension Ratios (SDR) presented on the Construction Drawings. B. Provide HDPE pipe with holes or slots formed in locations and with dimensions as shown on Construction Drawings. 2.03 PIPE COUPLINGS AND FITTINGS A. HDPE couplings, fittings and caps shall conform to the Construction Drawings and ASTM D3261. B. HDPE couplings, fittings, and end caps, and removable access caps at riser pipes shall be prefabricated. Fabricate, transport, and install consistent with the LManufacturer's recommendations and the Construction Drawings. C. Fittings and couplings shall be marked with the Manufacturer's name or logo, size, and material from which they were molded. D. All fittings and couplings, which will be fusion welded to the. pipe, shall be manufactured using the same resin and additives and shall be from the same Manufacturer as the HDPE pipe. SHAW ENV/RONMENTAL, /NC. San Joaquin County — Extension of Cap Corral Hollow Sanitary Landfill — CH—Closure Cap Ext Proj_Technical Specs -4-19-12 Revl.DocRev. 0, 09/28/2011 High Density Polyethylene (HDPE) Piping 02750-3