Laserfiche WebLink
Installation Gu'dO: �es �a���r� `� <br /> d anTex ' Systems <br /> 4 W2 <br /> Step 6a: Install the 2"PVC filtrate return line from the outlet <br /> coupling in the bottom of the AdvanTex pod to the inlet side of <br /> the split-flaw tee. This 2" filtrate return line should be sloped a <br /> minimum of 1/4"per foot..If the filtrate return line is less than 6' <br /> t <br /> long,provide a minimum of 1.5" total elevation difference from <br /> the outlet of the filter to the inlet of the split-flow tee. Be sure the <br /> INIR�mtu.1 2" filtrate return line is continuously sloped. <br /> NOTE. Do not allow any undulations or flat sections as this <br /> 4'- F <br /> will impair liquid and air movement. <br /> Step 6b: Be sure the split-flow tee is installed in the proper <br /> orientation. The filtrate return line connects to the end of the <br /> split-flow tee labeled"IN."The discharge pipe connects to the <br /> end of the split-flow tee labeled"OUT." <br /> Step 6c: When gluing the split-flow tee, orient it to <br /> accommodate the slope requirements of the discharge line. The <br /> discharge line should have a minimum slope of 1/4"per foot and <br /> a maximum slope of 2 inches per foot(10 degrees). If a slope of <br /> greater than 10 degrees is necessary, install the first 12 inches of <br /> the line at less than 10 degrees;then use fittings to achieve the <br /> necessary slope greater than 10 degrees. <br /> Step 6d: Plumb the discharge line from the split-flow tee, <br /> maintaining a 1/4"per foot slope. <br /> tA� <br /> a 2084 Orence Systemse Inc. KW&Ay1[A%-1 <br /> Rey&1.004 <br />