Laserfiche WebLink
black moly grease to the polypak as shown . Make <br /> STEP 5 : SAND THE UPPER DROP TUBE sure coverage is completely around the polypak <br /> Sand the inside of the drop tube with sandpaper seal . <br /> and/or steel wool to remove all burrs and sharp <br /> edges . After sanding wipe down the inside of the Ensure polypak <br /> tube with a clean rag from the top to approximately 4 lip is up <br /> inches down to remove any debris . — <br /> Caution : Failure to properly chamfer, sand , and % \ <br /> clean the drop tube may cut the seal and result Inlet <br /> in a failure of a pressure decay leak test. <br /> Tube ) \ Polypak <br /> Apply grease <br /> around polypak <br /> Figure 7 <br /> STEP 8 : INSTALL INLET TUBE <br /> Insert the inlet tube into the upper tube until the <br /> Ze \ upper tube seats against the flange on the inlet tube . <br /> Fine grit sandpaper Ensure polypak is inserted evenly and stays in inlet <br /> tube groove . <br /> Figure 5 <br /> STEP 6 : APPLY GREASE TO DROP TUBE <br /> Apply black moly grease to the inside diameter of <br /> the upper drop tube . Make sure coverage is <br /> completely around the tube as shown in Figure 6 . <br /> Q <br /> Figure 8 <br /> SEE PAGE 8 FOR INSTRUCTIONS USING THE <br /> 71 SO-TOOL . <br /> SEE PAGE 9 FOR INSTRUCTIONS USING THE <br /> Figure 6 71SOwTOOLC , <br /> STEP 7 : APPLY GREASE TO POLYPAK SEAL <br /> Ensure that the polypak seal is installed on the inlet <br /> tube with the lip up as shown in Figure 7 . Apply <br /> 67 <br />