Laserfiche WebLink
Introduction <br /> This section describes how to program the ISD system using the TLS console's front panel buttons and display. <br /> The procedures in this manual follow standard TLS console setup programming input, i.e., keypad/display <br /> interaction. If necessary, refer to Section 2 of the TLS-3XX System Setup manual (P/N 576013-623) to review <br /> entering data via the front panel keypads. <br /> All ISD-related equipment must be installed in the site and connected to the TLS console prior to beginning the <br /> setups covered in this section.As with all TLS connections,you cannot change sensor wiring or module slots after <br /> programming or the system will not recognize the correct data. Reference the section entitled "Connecting Probe/ <br /> Sensor Wiring to Consoles" in the TLS-3XX Site Prep and Installation manual (P/N 576013-879) for rewiring <br /> precautions. <br /> SYSTEM SETUPS <br /> • Smart Sensor Setup -All ISD sites- Figure 3 <br /> This setup mode function programs the Smart Sensor Interface module to monitor the Air Flow Meters and the <br /> Vapor Pressure Sensor. <br /> • EVR/ISD Setup-All ISD sites - Figure 5, Figure 6, Figure 7 <br /> This setup mode function programs the TLS console for EVR/ISD vapor recovery monitoring and reporting. <br /> • Verify Console Date/Time - Check the console front panel to confirm display of current date and time. Reset if <br /> necessary (refer to current date/current time setups in TLS-3XX System Setup manual). <br /> ALARM SETUPS <br /> One or ormore TLS setup functions must be programmed to shut down the tankor the dispenser if certain ISD <br /> alarms occur: <br /> • XLLD Line Disable Setup - For ISD sites with line leak detection - Figure 11 <br /> This setup mode function lets you assign ISD alarms to a line leak detector that will shut down the tank's STP. <br /> • Output Relay Setup - For ISD sites without line leak detection - Figure 13 <br /> This setup mode function lets you assign ISD alarms to a relay on the 4-Relay output module or 1/0 <br /> Combination module that will shut down the tank's STP. <br /> • For ISD sites with dispenser shutdown - Dispenser Relay Setup (go to Figure 15) <br /> This setup assigns ISD alarms to a relay that will shut down the dispenser. <br /> 10-B <br /> CARB Approved IBM 10 -Veeder Root ISD Install,Setup,9 Operation Manual-Executive Order VR-202 <br />