Laserfiche WebLink
STEP 9 B_ l.4grE TUBE ASSEMBLY FOR STANOARD VAPOR TKIW MQDELS,PROCEED <br /> if a vise is owd,clamp on the valve body tasting only to TO STEP2Q OW PAGE 14. <br /> avoid darnage to the f=and tubes. Thmad the lower <br /> tube onto the we NO!body until the lowet tube bottoms FOR TESTABLE MOVE15,PROCEED TO PAGE 13. <br /> our on valve body. Tube can be tighten�d by hand or <br /> with a soap wrench. If a strap wrench is used try to po- <br /> sitiori it on the threaded insert portion ofihe lower tube <br /> to prevent damaging the tube. <br /> Threaded Inse <br /> Flpt"18 <br /> NOTE:BeFvre installing the valve In the lank,a pr+es- <br /> aune test can be pe,rformred on the valveto check for <br /> vapor ftkne-m Sari off both on&a4 the tube with <br /> Inflatable piumbiWo plugs.Apply*nnaxlmu m IV <br /> W.C.(113 Psi)air pressure. ff pressure does not hold <br /> and a leakcan Ate kocated with soap Solution,do not <br /> instal!tlrevalm Swull the valve ba&to OPW for <br /> warranty eval"tlon. <br /> CALrrION:Do not over-pr�esswim. Peoess pre"ure <br /> can daarage the val", <br /> STEP 19: CUT LMM TUBE <br /> Wasurlmg from the underside of the inlet tube Flange, <br /> mark the overall iertgth of the drav tube a distance of <br /> 19}rninus6. Determinod►mension IB)from the meas- <br /> urcments taken in Step 1,Figure i (to p6f the Face Seal <br /> Adapter below the drain valve outlet}n the spill ccm- <br /> tainer to the bottotn of the tank). Saw off the excess <br /> tube at a 45-degree augia or per loca I codes or require- <br /> ments and file off any sharp burrs(Re(erto Figure 24)_ <br /> OpUonai: Install the DPW Tank Bottom Protector <br /> on the lower tube tRefef to%nstatlabpo i'nsnvctkmn zup <br /> plied with the Tank Bottom Protector)_ <br /> WPOfrrAMT:Remove all chips and shavings out of <br /> Ow cut imd of the tube. DO NOT regwwe chips and <br /> shavings by durnping thm valve body. <br /> r2 <br />