WORK PLANS - Laserfiche WebLink

Home Browse Search

+44"@ CENTER OF THE DOOR, AND MATTE FINISH @ A HEIGHT OF 60" FROM FINISH FLOOR. 12" DIA.MEDIUM IMPACT ABS PLASTIC SIGNS, 1. FLOOR SURFACE OF TOILET ROOM SHALL BE SMOOTH, HARD AND NON- 2. WALLS ARE SMOOTH, HARD AND NON-ABSORBENT TO 48" IN HEIGHT, ABSORBENT EXTENDING UPWARD A MINIMUM OF MIN. 4" ONTO WALLS AND ARE NOR ADVERSELY AFFECTED BY MOISTURE. 3. ALLOWABLE CLOSER PRESSURE SHALL BE 5 LBS. FOR INTERIOR DOORS, 4. DOOR HARDWARE TO BE OPERABLE WITH SINGLE EFFORT BY A LEVER 5. EXIT DOORS SHALL BE OPERABLE FROM THE INSIDE WITHOUT THE USE OF A KEY OR ANY SPECIAL KNOWLEDGE OR EFFORT. 6. NO THUMB LATCHES OR KEYED CYLINDER DEAD BOLTS ALLOWED ON ANY DOORS UNLESS OPERATED BY A SINGLE ACTION WITH A LEVER. 5 LBS. FOR EXTERIOR DOORS. LOCATED AT 37" A.F.F. WALL LIGHTS DIMMER SWITCH 220V DUPLEX RECEPTACLE RECESSED CEILING LIGHT PHONE JACK GFCI PROTECTED SSINGLE SWITCH CEILING LIGHTD EXHAUST FAN 50cmf MIN. SINGLE CEILING 48" FLOUR. LIGHT DROPPED LIGHT S (E) TENANT SIGN J-BOX TRACT LIGHTS MOTION SENSOR EXIT SIGN WITH OUTLET AIR DIFFUSER RETURN AIR DBL DUPLEX RECEPTACLE CEILING DUPLEX RECEPTACLE EXISTING DUPLEX RECEPTACLE C E 12 CIRCUIT NO. ELECTRICAL NOTES : 1. MATERIALS AND INSTALLATION, AS A MINIMUM, ARE TO CONFORM WITH THE LATEST EDITION OF THE NATIONAL ELECTRICAL CODE 2. THE ELECTRICAL CONTRACTOR SHALL BE RESPONSIBLE FOR PROPER BALANCING OF ALL CIRCUITS 3. LIGHT FIXTURES IN CONTACT WITH INSULATION TO BE U.L. LISTED FOR THERMAL BARRIER OR WITH 3" MINIMUM CLEARANCE 4. LIGHTS MUST NOT BE RECESSED IN FIRE RATED CEILINGS OF CORRIDOR UNLESS BOXED WITH EQUIVALENT CONSTRUCTION 5. THE DESIGNER ASSUMES NO LIABILITY OR RESPONSIBILITY TO ANYONE WHAT SO EVER AS A RESULT OF ANY INACCURACY OR CHANGE IN INFORMATION GIVEN ON WHICH THESE PLANS ARE BASED. CONTRACTOR MUST VERIFY ALL EXISTING ITEMS BEFORE START THE WORK 6. LIGHT SWITCHES SHALL NOT BE LOCATED BEHIND ANY DOORS OR EQUIPMENT 7. PROVIDE MULTI-LEVEL SWITCHING PER 2013 ENNERGY STANDARDS 8. LABEL ALL CB AND PANEL BOARDS 9. ALL EMERGENCY, EXIT, AND LIGHT LUMINAIRES SHALL BE CONNECTED AHEAD OF LOCAL SWITCHES. U.O.N 10. ALL LIGHT FIXTURES SHALL HAVE A DISCONNECTING MEANS WITHIN FOR SERVICE PERSONNEL 11. ALL 125-VOLT AND 20 AMPERE RECEPTACLES LOCATED IN THE KITCHEN TO BE GFCI PROTECTED 12. ALL 125-VOLT AND 20 AMPERE RECEPTACLES LOCATED WITHIN 6' OF THE OUTSIDE EDGE OF A SINK ARE TO BE GFCI PROTECTED 4. THERE WILL BE NO NEW EQUIPMENTS WEIGHT MORE THAN 400# AND NO NEW FIXTURES WEIGHT MORE THAN 20# MOUNTED OR SUSPENDED 1. ALL DOOR WIDTH TO BE 36 INCHES MIN. TO PROVIDE REQUIRED 32" CLEAR WIDTH WHEN OPEN. MAX. 48" ABOVE THE FLOOR, MIN. 15" A.F.F. 5. THE SCOPE OF WORK WILL INCLUDE ANY NECESSARY ACCESSIBILITY IMPROVEMENTS PER CBC 11B SEC. 202 8. ALL DEFERRED SUBMITTALS SHALL FIRST BE SUBMITTED TO THE THAT THE DEFERRED SUBMITTAL DOCUMENTS HAVE BEEN REVIEWED DESIGN OF THE BUILDING. THE DEFERRED SUBMITTAL ITEMS SHALL NOT DEFERRED ITEMS : SIGN PERMIT 6. SAFTY GLAZING MUST BE PROVIDED AT HAZARDOUS LOCATIONS PER OF A WALKING SURFACE, GLAZING IN DOORS, AND WINDOWS ADJACENT TO DOORS 7. A SEPARATE PERMIT FOR SIGN IS REQUIRED. 2. ALL RECEPTACLE OUTLETS ARE INSTALL AT NO LESS THAN 15" AND NOTES : 9. TERMINATION OF ALL ENVIRONMENTAL AIR DUCTS SHALL BE A MIN. OF (I.E., BATH AND UTILITY NO GREATER THAN 48" ABOVE THE FLOOR. 3. ALL SWITCHES, CONTROLS, THERMOSTATS, ETC. ARE INSTALLED FROM ROOF, CEILING, OR WALLS. CBC 2406.4, INCLUDING, BUT NOT LIMITED TO GLAZING WITHIN 18" REGISTER DESIGN PROFESSIONAL WHO SHALL REVIEW AND FORWARD THEM TO THE BUILDING OFFICIAL WITH A NOTATION INDICATING AND HAVE BEEN FOUND TO BE IN GENERAL CONFORMANCE WITH THE BE INSTALLED UNTIL DEFERRED SUBMITTAL DOCUMENTS HAVE BEEN REVIEWED BY THE BUILDING OFFICIALS. 3 FEET FROM ANY OPENNGS INTO THE BLDG. FANS, ETC...) MUST BE 3 FEET AWAY FROM DOORS, WINDOWS OPENING, SKYLIGHTS, OR ATTIC VENTS. SWITCH +44" ACCESSIBILITY NOTES : HVAC UNIT : YORK R-410A-DEX AFFINITY SERIES, 5 TON OR EQUIPVALENT DUCT SYSTEM : FLOW RATE : 698 FPM FLOW VOLUME : 800 CFM DUCT LENGTH : +100 FEET DUCT SIZE : 14" Ø, ROUND, FLEXIBLE NOTE : SMOKE DETECTORS SHALL BE LOCATED IN THE SUPPLY AIR DUCT OF THE SYSTEM AND CONNECTED SO THAT HVAC SUPPLY AIR IS SHUT DOWN UPON DETECTION OF SMOKE IN THE THE SUPPLY AIR DUCT C C E EEE+44+44+44"+44SSSSC DUPLEX OUTLET RECEPTACLE +18" E1 Revisions: Date: Page No:ADDRESS:OWNER:Drawn:RUBY BAKERY AND CAFEPERMIT#:SECOND CONTACT:APN#:11 S. CHURCH STLODI, CA 95240ZERTUCHE DRAFTING & DESIGN HORACIO ZERTUCHE 1050 N. CARPENTER, SUITE-J MODESTO, CA 95351 (209) 507-6036 horacio@zertuchedrafting.com FAUSTO ECHEVERRIALYNN ECHEVERRIA(415) 404-519409/01/20191 10/04/20192 11/21/20193ELECTRICALPLAN Scale:1/4"-1'-0" ELECTRICAL PLAN 1 1 1 1 1 1 2