WORK PLANS - Laserfiche WebLink

Home Browse Search

FINISH CARPENTRY AND MILLWORK Section 06200 15-1207 3.03 INSPECTION A. Prior to installation of the work of this Section, carefully inspect and verify that the installed work of all other trades is complete to the point where this installation may properly commence. B. Verify that specified items may be installed in accordance with the approved design. C. In the event of discrepancy, immediately notify the Architect. Do not proceed in discrepant areas until discrepancies have been fully resolved. 3.04 PROTECTION A. Protect work and materials of this Section and other sections prior to and during installation, and protect the installed work and materials of other trades. B. In the event of damage, make all repairs and replacements necessary to the approval of the Architect at no additional cost to the Owner. C. Exposed finish shall be free from scratches, dents, permanent discolorations and other defects in workmanship or material. 3.05 INSTALLATION A. General: Do not install millwork until wet operations are completed; the concrete, masonry and plaster work has thoroughly dried and the millwork has been primed or sealed in an approved manner. B. Installation of finish carpentry and millwork shall conform to the applicable requirements of the Architectural Woodwork Standards, WI. C. Interior Frames: Install plumb, square and true, securely wedged and anchored to structure. Countersink fasteners. D. Trim Members: Install level, plumb and true, with member neatly and accurately scribed in place. Install trim in single lengths, running trim in as long a length as practical for species specified. Butt joints to be back -beveled, exterior and interior angles mitered. E. Fastening: All nails or screws to have required penetration into holding member per Title 24, Table 2304.9.1. 1. Exterior Trim: 10d nails or less, use finish nails set 1/16 inch below face, without putty. 10d to 20d nails, use common nails driven flush without hammer marks and putty. 20d or over, use common nails driven flush without hammer marks and putty. 2. Interior Trim: Set nails or appropriate screw fasteners 1/16 inch below face, with putty. No putty where finish will be clear. 3. Exterior Plywood: Nails long enough to penetrate structural backing 1 inch. Use galvanized box nails, driven flush without hammer marks. 4. Interior Plywood: Install with grain texture vertical, with edges and ends occurring only over bearings. Use aluminum or stainless steel finish nails in 8d size for 5/8 inch thick plywood and 6d for 3/8 inch thick plywood. Nail 6 inches on -center along all sheet 5