Laserfiche WebLink
FINISH CARPENTRY AND <br />MILLWORK <br />Section 06200 <br />15-1207 <br />perimeter edges and 12 inches o.c. along all intermediate bearings. <br />F. Plywood Wainscot (Interior): All joints to bear on studs or blocking. Attach with 2-1/2 inch x <br />1/4 inch flat head screws, counter sunk at 8 inch o.c. at edges and at studs in field. Caulk <br />joints. <br />G. Panels and moldings are to be mechanically fastened through gypsum board backing and <br />into wood or metal studs with anchors per manufacturer's recommendation. Provide in <br />addition to anchors, construction adhesive per manufacturers recommendation. Provide <br />continuous sealant to all panel molding connections to make waterproof. Moldings shall be <br />detailed so as not to cause damage to adjacent moldings or panels if vandalized or removed. <br />H. Plywood Flooring: Screw attach to wood floor system, 12 inch on -center at edges, 16 inch <br />on -center at field. Seal floor per Section 09900. <br />3.06 WORKMANSHIP <br />A. Exposed surfaces shall be free from tool marks, torn grain, cross sanding, or workmanship <br />defects that cannot be concealed by specified painter's finish. <br />END OF SECTION <br />i.11207lincoln as - cafeteria replacement14.06 projman106200 finish carpentry millwork.doc <br />Last Updated: November 3, 2011 <br />L <br />