WORK PLANS - Laserfiche WebLink

Home Browse Search

ENTRANCES & STOREFRONTS Section 08410 15-1207 2.05 FINISHES A. Factory Finishing: 1. Kawneer Permanodic@) AA-M12C22A44, AAMA 611, Architectural Class I Color Anodic Coating (Color to be selected by Architect). 2. Kawneer Permanodic® AA-M12C22A41, AAMA 611, Architectural Class I Clear Anodic Coating (Color #14 Clear) (Optional). 2.06 ENTRANCE HARDWARE A. See 08710, Finish Hardware 2.07 ACCESSORIES A. Fasteners: Where exposed, shall be Stainless Steel. B. Gaskets: Glazing gaskets shall be extruded EPDM rubber. C. Perimeter Anchors: Aluminum. When steel anchors are used, provide insulation between steel material and aluminum material to prevent galvanic action. PART 3 - EXECUTION 3.01 INSPECTION A. Prior to installation of this work, carefully inspect and verify that the installed work of all other trades is complete to the point where this installation may properly commence. B. Verify that specified items may be installed in accordance with the approved design. C. In the event of discrepancy, immediately notify Architect. Do not proceed in discrepant areas until discrepancies have been fully resolved. 3.02 COORDINATION A. To facilitate installation, it shall be the responsibility of the window supplier to properly prepare the vents to accept the operators and to insure the vents are properly hung for finger- tip operation providing free movement to the control systems. Vent preparation details shall be shown on the Control Systems Shop Drawings and installation instructions for the erector shall be provided at the time of delivery. B. Prior to fabrication verify that all hardware may be properly installed. 3.03 INSTALLATION A. General: Install framing system in accordance with manufacturer's instructions and AAMA storefront and entrance guide specifications manual. Dissimilar Materials: Provide separation of aluminum materials from sources of corrosion or electrolytic action contact points. 5