WORK PLANS - Laserfiche WebLink

Home Browse Search

FOOD SERVICE EQUIPMENT Section 11400 15-1207 All socket ports shall be finished off with a '/2' diameter snap cover to match the color of the panels. 5. Hinged Walk-in Doors: Door shall be installed as shown on the drawings. Door shall be urethane insulated, flush -in fitting type 42" wide x 80" high (as shown on the drawings) with triple pane 1/4" thick plate glass view windows (freezer heated). Each door shall be furnished with door heater switch and mortise style lock. Door finish to be 20 gauge stainless steel inside and out. Door and door section shall be listed by UL and equipped with the following: a. Magnetic gasket b. Door closer with 5 lbs max opening force. C. Polished chrome deadbolt latch and cam -lift spring-loaded hinges d. Latches shall have a safety release to prevent entrapment of personnel within the box. Latches also have padlocking provisions. e. Bottom of door shall have a double sweep gasket. Magnetic gasket shall be of a dart and ridge design that will allow for easy replacement by the end user without the use of any tools. The door jamb shall be constructed of a fully welded anodized aluminum rigid frame. The perimeter of the frame shall be no less than two inches wide to provide integral backing to accommodate all required hardware. Freezer door jambs shall also have a 120 -volt jamb and threshold heater with a snap -on easily removable stainless steel channel and a heated pressure relief vent assembly listed by UL. f. Each entrance door shall be provided with a 3 -way rocker light switch with an indicating pilot light exterior. All switches are pre -wired and factory tested per UL. All light fixtures are optional. g. A threshold shall be provided with the door section. Heater wire shall continue beneath the threshold (freezer) in a raceway. h. A digital thermometer shall be included with each door section to indicate inside temperature. 6. Lights: Each door section shall be equipped with a flush mounted constant burning pilot light and switch on exterior and interior factory wired to an interior LED Fixture Kason 1806. Each compartment shall be provided with ceiling mounted vapor proof LED light fixture with clear prismatic injection molded polycarbonate diffuser Kason model 1810 or equal, see drawings for quantity. Light fixtures shall be factory wired to the light switch at the entrance door. Lighting level shall be a minimum of 10 foot candles measured 30" off the finished floor. 7. Finish: Finished: Exterior wall panels, exposed to kitchen shall be 22 gauge stainless steel finish. Ceiling panels and door panels shall be a minimum of .026 galvanized steel with baked enamel embossed white finish and where concealed shall be .026" galvanized steel. Interior wall and ceiling panels shall be .026" galvanized steel and finished in baked enamel embossed white finish. Interior of prefab wearing floor shall have .1875 #6061-T6 aluminum tread plate. (Anti -Skid Surface). Tread plate to be continuous up side wall (1/2" seamless radius) terminating above interior floor surface, as required. Interior walk-in box to be set in depression as shown. Interior kitchen finish floor to meet interior floor panel of walk-in at same elevation for an even transition into walk-in. 8. Accessories: Assembly shall be provided with the following accessories. 14