Laserfiche WebLink
PREFINISHED PLASTIC <br />LAMINATE CASEWORK <br />Section 12304 <br />15-1207 <br />satin chrome finish. Locate and mount surface bolt on door far enough below <br />shelf to allow for %-inch deflection of shelf and also to allow for proper <br />engagement of surface bolt and angle strike. <br />6. Drawer Guides: Accuride, Heavy Duty Slides as scheduled below: <br />a. Drawers to 36 -inches Wide: Model 3832 - (provide appropriate length). Rated <br />for 100 -pounds. <br />b. Drawers 36+ -inches to 48 -inches Wide: Model 4034 (provide appropriate length). <br />Rated for 200 pounds. <br />C. Drawers 42+ -inches to 48 -inches Wide with face heights of 7 -inches or more: <br />Model 3640 - (provide appropriate length). Rated for 200 -pounds <br />7. Adjustable Shelf Supports: Universal 1, shelf supports manufactured by Hettich <br />International. <br />8. Garment Hooks: <br />a. Double -prong for wall installation; Hafele 845, or accepted equal. Install at 6 - <br />inches on -center unless otherwise noted or shown in drawings. <br />b. Triple -prong for ceiling / under -shelf installations: Hafele 846, or accepted equal. <br />Install at 12 -inches on -center unless otherwise noted or shown in drawings. <br />K. Keyboard Tray: Compx Ergonomx 4475D1 2E Sliding Keyboard Support or approved equal <br />L. CPU Holder: Hafele, CPU Holder with Swivel and Extension, catalog no. 639.72.310 or <br />approved equal. See Part 3 of these specifications below for underside of countertop <br />blocking and installation requirements. <br />M. Miscellaneous Accessories and Materials: <br />1. Provide all accessories and materials as required for finish casework. <br />2. Miscellaneous Fasteners: Provide screws, staples, dowels and adhesives in <br />accordance with specified standards and as required. <br />3. Joint Fasteners: Knape & Vogt, #513 Joint Fastener. <br />4. Mirrors: ASTM C1036, 1/4 inch thick No. 1 (mirror glazing) quality, clear polished plate <br />glass with protective copper backing over silver coating and nonmetallic elastic paint; <br />ground edges, with clip attachment; provide one 12 inch wide x 36 inch high mirror, <br />mounted at 34 inches above finish floor from the bottom of the reflective surface, at <br />each teachers' cabinet. <br />5. Grommets: Doug Mockett & Company, Inc. EDP Series, round plastic grommet, 2-1/2 <br />inch hole, cap with cord slot. Colors from minimum 8 selections. <br />6. Countertop Braces: A&M Brace as manufactured by A & M Hardware, Inc. or accepted <br />equal. Size brace appropriate with size of countertop. Provide Hebgo (1100 Ib. <br />capacity) bracket as manufactured by Hafele at locations where continuous raceway <br />runs directly below countertop brace. Provide largest brace available for given <br />countertop depth to achieve maximum countertop support. <br />PART 3 - EXECUTION <br />3.01 CABINET COMPONENTS: <br />A. Cabinet Bodies: Fabricate, assemble and finish each cabinet as complete, self-supporting <br />unit. Unless otherwise shown, counter and tall storage units shall be 24 -inches minimum <br />overall depth; wall -hung units shall be 15 -inches minimum overall depth unless otherwise <br />7 <br />