WORK PLANS - Laserfiche WebLink

Home Browse Search

MECHANICAL GENERAL CONDITIONS Section 15010 15-1207 B. Information shown relative to existing services is based upon available records and data but is approximate only. Make minor deviations found necessary to conform with actual locations and conditions without extra cost. Verify location and elevation of utilities prior to commencement of excavation for new piping or its installation. C. Exercise care in excavating near existing utilities to avoid any damage thereto. This Contractor is responsible for any damage caused by his operations. 1.08 MATERIAL LIST AND SUBSTITUTIONS: A. Prior to commencement of work, and within 35 days after award of Contract, submit to Architect for review electronic copies of a complete list of equipment and materials to be furnished, including all substitutions. All submittals to be in electronic format as follows: 1. Submittals to be in PDF Format. 2. Individual PDF cut sheets shall be inserted into a single file for review. 3. All sheets to be "unprotected" and writable. B. Provide submittal information for all materials proposed for use as part of this project. Provide standard items on specified equipment at no extra cost to the contract regardless of disposition of submittal data. Other material or methods shall not be used unless approved in writing by the Architect. The Architect's review will be required even though "or equal" or synonymous terms are used. C. It is the responsibility of the Contractor to assume all costs incurred because of additional work and/or changes required to incorporate the proposed substitute into the project including possible extra compensation due to the Architect. Refer to Division 1 for complete instructions. D. Contractor to provide complete Submittal packages for each system. At a maximum, submittals to be broken into the following packages: 1. Plumbing — Fixtures, Trim, Piping, Equipment, Accessories, etc. a. When required by schedule, a separate Plumbing Underground submittal package will be reviewed upon request. 2. Mechanical: Ductwork, Piping, Source Equipment, Accessories, etc. 3. Mechanical — Building Automation System 4. Mechanical — Duct coordination shop drawing package. E. Identify each item by manufacturer, brand, trade name, model number, size, rating, or whatever other data is necessary to properly identify and review materials and equipment. 1. Where submittal sheets indicate more than one product, Contractor to clearly identify product being submitted. Contractor to cross -out information not being submitted for review. 2. Submittals that do not clearly identify submitted item will be returned to the Contractor un -reviewed. F. Identity each submitted item by reference to specification section number and paragraph in which item is specified. Cross reference submittals by equipment ID where applicable. G. Quantities are the Contractor's responsibility and will not be reviewed. 3