INSTALL_2021 - Laserfiche WebLink

Home Browse Search

office for review & to address required items in order to obtain CUPA Permit/Approved Plans for proposed installation of new ust's & related upgrades/improvements to be completed at the subject facility (please download the files as soon as possible, the link never expires but when a long time goes by without accessing/downloading the files with the link, they might no longer be available); https://asengineering.sharefile.com/d-s22c983bf99724fd7bOcb5c459c72ecb9 • Updated UST Installation Permit Application • Manufacturer's cut sheets for proposed ust system components • Updated plans for review/approval for proposed installation of new ust's & related upgrades/improvements Below please also find your latest plan check comments received highlighted in blue including our responses highlighted in yellow; 1) Complete manufacturer certifications were not submitted. Provide current contractor's training certifications for installation and testing of all proposed UST equipment/components, including tanks & sumps, flex connectors, piping, spill buckets, sump shields & lids, leak detectors, and overfill prevention. A number of the attached certifications have expired and there is not a certification for each part being installed. Please follow the link to access certifications received from contractor, if certifications are still not the correct ones, please advise specifically which ones are acceptable & which ones you are still missing. Certification for the following are still needed: • NOV - piping • Franklin Fueling/Flex-ing - flex connectors • Hosemaster—flex connectors • Franklin Fueling—spill containers • Fiberlite— water -tight shield • Veeder Root — leak detectors Required certifications will follow shortly as soon as received from contractor Savidge Construction Inc. 2) Provide manufacturer's cut sheets for all proposed UST system components, including piping, flex connectors, STP & fill sumps, UDCs, vent sumps, penetrations, spill buckets, and overfill prevention. l found a link in one of the emails but it says that it is an "invalid link". Please follow the link to access manufacturer's cut sheets, if it still says that the link is invalid (which 1 checked & was able to access again without any problem) we can overnight hard copies or a usb drive including all plans & documents to your office, if manufacturer's cut sheets are still not the correct ones, please advise specifically which ones are acceptable & which ones you are still missing. Cut sheets for the following were not submitted: • tank STP sump and tank fill sump Included in the tank package. • Under Dispenser Containment — The application lists B-925x-FXL BD -AB but that is not one of the part numbers on the Bravo B-9000 cut sheet. This cut sheet also states that this is a single walled UDC. Will you be installing a single walled UDC? We'll use double wall (Bravo 89250-D36). Please see new cutsheet & revised sheet M.5.3.02 (Item #85). • Electrical penetrations F -17 -RR -D and F -10 -RR -D - not listed on the Bravo cut sheet submitted. F -17 -RR -D and F -10 -RR -D are old part #s. Please see new cutsheet & sheet M.5.3.02 (Item #124) for new model #. Franklin Fueling FFlOX12HMX346 flex connect is not listed on the Flex-ing Flex Connector cut sheet. Or is the end of this part supposed to be "...F346"? Then it would fit something on this cut sheet. The end of the model number should be M346. Please see revised sheet M.5.3.02 (item #171). 17