COMPLIANCE INFO_1995-2008 - Laserfiche WebLink

Home Browse Search

Install the valve in separate bypass piping and connect the plastic tubing as shown in Fig. 7. LOADING THE TANK 1. Position the tank so that the fillport is in the front or the rear. NOTICE: For PV -A units with an Aqua -Sensor® sensing device, the fillport must be in the rear. 2. Slip a Tetraseal gasket, obtained from the small parts package, up the long outlet manifold until it seats below the manifold collar (Fig. 8). 3. Install the outlet manifold into the LEFT (outlet) flange port (Fig. 8). A CAUTION: DO NOT install the outlet manifold into the right flange port. Media will be flushed to service. 4. Slip the other Tetraseal gasket up the short, wide -slot inlet manifold until it seats below the manifold collar, then install the inlet manifold in the RIGHT (inlet) flange port. 5. Cover the tops of the manifolds with a clean rag. 6. Using a large -mouth funnel, load the coarse sand underbedding through the fillport. A CAUTION: DO NOT allow the outlet manifold to move when loading the media. The manifold must remain vertical to ensure a good seal at the gasket. Rap the tank near the bottom with a rubber mallet to level the sand. 7. Aqua -Sensor sensing device units only - A. Measure the sensor cable length as shown in Fig. 9 A CAUTION: The sensor has a plastic protective cover which should not be removed until the FILL PORT ` . INLET MANIFOLD OUTLET MANIFOLD GASKET GASKET`+ FIG. 8 10 / HI-FLO® 2 WATER SOFTENER sensor is ready for installation. Avoid touching the carbon rings since oil and dirt can affect the sensitivity of the sensor. The sensor may be cleaned by wiping it with a moistened paper towel which has been sprinkled with household cleaner - rinse thoroughly. B. Moisten the cable sheath and slide the cable grip up or down to the proper cable length. C. Tighten the compression nut so that the fitting cannot slide along the cable. D. Locate the 1.25" NPTE x 0.5" NPTI PVC bushing (packed with the manifolds). Insert the probe and cable through the bushing. E. Wrap the threads of the compression fitting with Teflon tape, then screw the fitting into the bushing. F. Remove the large -mouth funnel. Insert the probe and cable through the fillport. NOTICE: There must be no kinks or bends in the cable. Protect the cable sheath from being cut by the fillport threads, then reinsert the funnel. 8. Load the tank with the Cullex® ion exchange resin. Leveling is not required. Remove the funnel. 9. Wrap the threads of the PVC reducing bushing with Teflon tape and screw the bushing into the fillport. 10. Timeclock units only - Wrap the threads of the 0.5" PVC plug (packed with the manifolds) with Teflon tape and screw the plug into the bushing. FIG. 9 HI-FLO® 2 SENSOR CABLE SETTING PV -45 36in (.91 m) SEE PV -60 35in (.89m) CHART PV -90 47in (1.2m) PV -120 59in (1.5m) PV -135 59in (1.5m) FIG. 9