COMPLIANCE INFO_1995-2008 - Laserfiche WebLink

Home Browse Search

5. Transfer the O-ring from the beige cductor nozzle to the appropriate nozzle from the small parts pack. 6. Lubricate the O -rings with silicone lubricant. 7. Install the new nozzle into the eductor throat, then install the assembly into the valve. The locating plate on the throat should face to the rear of the valve. Be certain both the nozzle and the throat are fuTnly seated. 8. Reinstall the eductor screen. NOTICE: The screen is intended to protect the eductor nozzle from being plugged by dirt. This protection is less critical for the larger nozzles. If the hard water contains iron but no large particles, the screen should not be used. 9. Reinstall the eductor cover with the three screws. A CAUTION: Be sure the eductor cover gasket is properly sealed in its groove, or the valve may leak. NOTICE: If other optional kits are to be installed in the control, it may be more convenient to install the kit(s) in the control at this time. The duplex plugs should not be installed until after the control is mounted on the tank A CAUTION: Each tank port contains a white plas- tic bushing with an O-ring below it. DO NOT remove these bushings, or there will be a leak. Locate the eight 0.5" hex -head bolts in the small parts pack. Place the control on the tank and secure it to the tank in the rear with one bolt to prevent the control from falling forward. A CAUTION: The control must be properly seated on the manifold gaskets, or the connection will leak. Wiggle the control valve until it seats. FIG. 12 12 / HI-FLO® 2 WATER SOFTENER Install the remaining seven bolts and tighten the bolts with an open-end wrench. Verify that the Flo-Pakj.M tubing on PV -B units has been connected as follows (Fig. 13). Solenoid Port No. Valve Connection 1 Flo -Pak Tee 2 Eductor Cover 3 Drain Fitting (Top) Complete the connections by connecting the piping to the rear (PV -A units) or top (PV B units) of the control. SALT STORAGE CONTAINER Place the salt storage container on a smooth, level surface as near to the media tank as possible. Rough surfaces or foreign objects under the tank can result in uneven stresses which can crack or puncture the container. Rotate the container until the brine valve chamber is in the rear. NOTICE: For PV -120A, PV -120B, and PV -135B models, remove the 0.8 gpm flow control from the top of the brine valve and replace it with the 1.4 gpm flow control from the small parts pack. OPTIONAL (LARGE-SIZED) PLASTIC BRINE TANK ASSEMBLY NOTICE: When using Optional Plastic Brine Tanks with PN 00-7736-80 Industrial Brine Valve, order PN 00-3407-40 adapter kit. INSTRUCTIONS: 1. Locate the brine tank approximately 6 inches from the softener tank. BRINE SAFE? VALVI IBER