Laserfiche WebLink
2. Assembly the ell and PN 00-3047-40 adapter kit to the <br />top of the brine valve and attach the plastic brine line to <br />the safety valve. <br />CONNECTING BRINE AND DRAIN LINES <br />Brine Line <br />Measure the amount of brine tubing needed to reach from <br />media tank to salt storage container, then add four feet to <br />permit easy removal of the brine valve. Cut both ends of the <br />tubing squarely. <br />Life the brine valve out of the brine chamber. On the brine <br />valve float stem you will find a white plastic nut and insert. <br />Slip the stem out of its upper retainer, remove the nut and <br />insert, and return the stem to its original position. These <br />FIG. 13 <br />I II <br />/ 1 <br />DUPLEX TEE Po:�PR0 <br />INSERT <br />TO BRINE UNE <br />ADAPTER FITTING <br />SOFTENER UNIT A <br />�Flg 3) <br />��7 <br />TO BRINE LINE <br />ADAPTER FITTING <br />SOFTENER UNIT B <br />IF.g 3) <br />TUBING <br />t <br />NUT — PLASTIC <br />(00-"04-02) <br />POLYP440INSERT <br />(OOdWS-16) <br />BRINE SAFETY VALVE <br />FIG. 14 <br />parts will be used to connect the brine line to the brine valve. <br />A plastic fitting can be found in the small parts pack for con- <br />nection of the brine tubing at the control. Install the brine <br />line as follows: <br />1. Slip the plastic nut over one end of the tubing, press a <br />plastic insert into the end of the tubing, and connect to <br />the brine valve. Tighten the plastic nut. <br />2. Remove the white plastic nut from the small parts pack <br />and slip it over the other end of the brine tubing. Press a <br />plastic insert into the end of the tubing and tighten the <br />nut securely to the brine connection. <br />DUPLEX MODELS <br />BRINE SYSTEM ASSEMBLY <br />Duplex models using a common brine tank should be <br />assembled as follows (Fig. 14): <br />1. Cut off approximately 2 inches of brine tubing and <br />assemble to the brine safety valve. <br />2. Connect the center leg of the duplex tee provided <br />PN 00-3030-80 to the other end of the tubing. <br />3. Connect the brine line tubing from each softener to the <br />two remaining ends of the duplex tee. <br />Drain Line <br />Locate the pipe clamp in the small parts package and the <br />length of 1/2" drain line (not furnished with the conditioner). <br />1. Slide the hose clamp over the end of the drain line, push- <br />ing it several inches from the end. <br />2. Push the end of the drain line over the drain fitting and <br />move the clamp up to within 1/4" of the end of the tube <br />to get a tight seal (Fig. 15). Tighten the screw on the <br />clamp. <br />FIG. 15 <br />INSTALLATION / 13 <br />