Laserfiche WebLink
l <br /> ® Anthon � Model 401 & 403 Pass-Thru <br /> y Service and Installation Instructions <br /> •�. 99-21972-S001 Rev. A <br /> d. Continue to step 7. <br /> e. Place the plastic extrusion notch toward the top of the Mullion. <br /> Vertical <br /> Mullion <br /> Plastic Shield <br /> f. Using a Phillips screw driver, thread a #8 tapping screw through <br /> the plastic extrusion. <br /> Plastic <br /> Shield <br /> 0''S Verticle Mullion <br /> at CIL <br /> g. Continue to step 7. <br /> 7. Position the center punch directly over the vertical line and within the plastic <br /> extrusion notched cutout, establish a dimple. <br /> - Plastic <br /> � Shield <br /> Vertical <br /> Mullion <br /> 8. <br /> 8. Use a power drill and (3/8") 0.375" dia. drill bit, drill (1) hole. <br /> 9. Snap the LED fixture into the plastic extrusion. Refer to "Wiring Diagrams and <br /> Orientation" and "Parts List". <br /> 10.Thread the LED wires through the 3/8" hole. <br /> 11.Align the LED fixture with the vertical lines made in step 2 and using a center <br /> punch, establish two dimples, one at the top and one at the bottom of the end <br /> clips. <br /> 12.Use a power drill and (1/8") 0.125" dia. drill bit. Drill (2) holes through the LED <br /> top and bottom mounting brackets through the plastic extrusion. <br /> d.,. <br />