INSTALL_2024 - Laserfiche WebLink

Home Browse Search

34 c. #813 is listed at each UDC. #813 is a PLLD mount. Are you installing leak detectors in each UDC? Alternatively, you don’t have any of these mounts located where leak detectors are shown (#812) in the turbine sumps. d. #823 is listed at each tank sump and UDC. This is a sensor kit that contains a 304 and 208 sensors. But you have these sensors listed separately in the materials list and in this diagram (#806 and #815) as well as this kit (#823). Are you installing 2 sets of 304 and 208? You do not have #315 listed at the UDCs but the quantity listed for this 208 sensor is 23, but there are only 11 listed in the diagram. e. #808 are probes shown in the fill sumps. Probes are typically not located here. f. #808 is shown 4 times on this diagram (at each fill sump) but you only have a quantity of 2 listed on the materials sheet (T&L7). Ensure this matches the correct amount to be installed throughout your plan. g. #812 is shown 4 4 times on the diagram (at each turbine sump) but you only have a quantity of 1 listed on the materials sheet (T&L7). Ensure this matches the correct amount to be installed throughout your plan. h. Item 2 on the list points at the 30k tank as a “NEW UST” but not at the 32k tank. Is the 32k tank not a new UST? i. Item 8 on the list states that there will be 6 #300 dispensers but there is only a quantity of 4 lists on the materials sheet (T&L7). Ensure this matches the correct amount to be installed throughout your plan. j. #833 is shown in the store but there is no #833 on the T&L7. What is this item? k. Note 7 shows two “D” pipe lengths but doesn’t specify which is for B20 and which is for B. It also indicates one is 4” over 3” at 380”, this is measured in inches and not feet? Why is one diesel 3” over 2” and the other 4” over 3”? l. There is no chase piping being monitored shown in the vacuum zones 7. Sheet T&L2 1. Detail C6