Laserfiche WebLink
PROGRAMMING - H5-E, H5-PC, H5X, H10X <br />MODEL DISPLAYS (PI) <br />Hl B <br />O <br />LEVEL 1 PROGRAMMING <br />NOTE: If the unit is a H5X or H10X, set the Tank Temperature to 212°F. <br />46819 043012 <br />m|O| <br />BOWIKW <br />Continued <br />9 <br />LEFT <br />BUTTON <br />CENTER <br />BUTTON <br />RIGHT <br />BUTTON <br />(H5H) 5 Gallon High Voltage Unit (200-240V) <br />(H5L) 5 Gallon Low Voltage Unit (100-120V) <br />(HPC) 5 Gallon Portion Control Unit (all) <br />(H10) 10X (all) <br />(♦) <br />» o <br />(-) <br />When power is applied to the dispenser, the display located on the bottom of the main circuit board will show <br />the software version for 5 seconds, and then it will show the model number (see chart below) it will then go <br />to (-). While the tank is filling, the display will read (FIL). When the tank is full the display will show the model <br />number and then go to (-). _______________________________________ <br />Switch must be in “SET” position for <br />access into programming modes. <br />EIM1. Before programming any settings into the Control Board, confirm the correct model <br />number entered. <br />2. Do this by pressing and holding down on the center button until P1 appears on the ■■■ ■^■1 <br />display. Release the center button. The display will now show the model number H 0^ I <br />(ex: H5H). Now scroll with the (+/-) buttons through the models listed above until <br />the display matches the model you are working with. HI ■■■ <br />3. Press and release the center button once more. The display will show P2. Display _ _ <br />will now show the tank temperature (ex: 200). Press the (+) button to increase the Eg ' <br />temperature set point, or the (-) button to decrease the set point. Ifi|l <br />4. After the Tank Temperature is entered, press and release the center button once KSI MM MM <br />more. The display will read P3, then show the ready temperature set point. Factory Id ISE <br />default is 195° F for most dispensers, and 85° F for some. <br />5. Press the (+) button to increase the set point, or the (-) button to decrease the set <br />mIEh^h6. To exit Level 1 Program press and release the center button once more. The display ESI <br />will show Software version, then model number, then (-).