Laserfiche WebLink
PROGRAMMING - H5-E, H5-PC, H5X, H1OX Continued <br />LEVEL 2 PROGRAMMING <br />H2 - F° OR C° SELECTION <br />Bill <br />2. <br />4. To exit Level 2 Programming press and release the center button once more. The display will show the <br />Software version, then model number, then (-). <br />io 46819 043012 <br />BISI <br />SSBI <br />BIB <br />BBB <br />BBS <br />BBBOr to exit Level 2, press and release the center button 3 times. Display will show, <br />software version, then model number, then (-). <br />NOTE: Skip step 1 if going from HI to H2. <br />1. To enter Level 2 Programming, press and hold the center button until H2 appears <br />on the display (approximately 6 seconds). Release the center button, The display <br />will show either FAN (Degrees in Fahrenheit) or CEn (Degrees in Centigrade). <br />2. Press and release the (+) or (-) buttons to alternate between FAN and CEn. <br />3. After setting FAH or CEn, to exit Level 2 Programming, press and release the center <br />button twice. Display will show, software version, then model number, then (-). <br />HI - DISPENSE TEMPERATURE LOCKOUT - PORTION CONTROL ONLY <br />(WILL NOT DISPLAY ON OTHER MODELS) <br />1. To enter Level 2 Programming, press and hold the center button until H1 ap­ <br />pears on the display (approximately 6 seconds) then release button. The display <br />will either read noL (LOCKOUT DISABLED) or Loc (LOCKOUT ENABLED). When <br />(ENABLED), unit will not dispense if the Tank Temperature is below the (READY) <br />temperature setting. <br />2. Use the (+) or (-) buttons to alternate between Loc and noL. <br />3. Press and release the center button once more to advance to H2. <br />NOTE: If you release the two buttons at any time before the display reads don, the Fac­ <br />tory Default numbers will not be entered. The old numbers will remain in the memory. <br />H3 - RESTORING FACTORY DEFAULTS <br />1. To restore Factory Defaults (This clears all settings that were previously entered), <br />press and release the center button until H2 appears on the display (approximately <br />6 seconds). Release the Center Button, then press and release the Center Button <br />once more. The display will read H3, then show (- - -). <br />Press and hold both (+) and (-) buttons to initiate the resetting of the factory <br />default settings. The display (- - -) will flash on and off during this time (about 5 <br />to 7 seconds). <br />3. When the factory default numbers are loaded in, the display will stop flashing, <br />then read don (DONE). You can now release the two buttons.