Laserfiche WebLink
PROGRAMMING - H5-ELEMENT <br />Step forward <br />IBS <br />' V1®! A WARNING <br />&Step backward <br />Continued <br />46819 06121211 <br />READY <br />ENERGY WER MODE <br />Hot Water <br />Refer to chart on page 3 and adjust temperature <br />requirements according to altitude. <br />Adjusting temperature: <br />The switch must be in the “SET” position in order to <br />access the program modes. <br />1. Press and hold “TEMP" button until display <br />flashes. <br />2. While display is flashing, press and release the <br />(+) to increase or (-) to decrease temperature. <br />NOTE: (Starting with software version 0.06) <br />If unit is “E” model, temp will stop at 210°F (99°C). <br />If unit is “X” model, temp display will jump from <br />210°F (99°C) to 212°F (100°C). <br />BUNN <br />Programming the dispenser: <br />1. Press and hold upper hidden button (bottom <br />center of “BUNN” logo) until “P1” is displayed. <br />SEI <br />SEE <br />Manual Energy Saver Mode: <br />The energy save mode will allow the tank temperature <br />to drop down to 140°F (60°C). <br />1. Simultaneously press and release the (+) and (-) <br />to “manually” activate energy save mode. <br />2. The display will alternately flash between 140 <br />and the current temperature to indicate it is in <br />the energy save mode. <br />3. Repeat procedure to exit energy save mode. <br />Program lockout switch: <br />The switch must be in the “SET” position in order to <br />access the program modes. <br />1. Disconnect the dispenser from the power source. <br />2. Remove the 4-40 screws and the top cover. <br />3. Use a small screwdriver to move switch to set <br />position. <br />4. Install top cover, connect dispenser to power <br />source. <br />EMI