COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

Page 4 of 8 6. PIPING SUMP TESTING Test Method Developed By: ❑ Sump Manufacturer 0 Industry Standard ❑Professional Engineer ❑ Other(Specify) Test Method Used: ❑ Pressure ❑Vacuum IF)Hydrostatic ❑ Other(Specify) Test Equipment Used: Caldwell Equipment Resolution: Sump 1 Sump 2 Sump 3 Sump 4 Sump Diameter: 46" 46" 46" 46„ 9„ 62" 45" 5 Sump Depth: 57" Sump Material: Fiberglass Fiberglass Fiberglass Fiberglass Height from Tank Top to Top of 15" 15" 14" 17" Highest Piping Penetration: Height from Tank Top to Lowest 10" 10,E $" 20" Electrical Penetration: Condition of sump prior to testing: Dry Dry Dry Dry Portion of Sump Tested' 2"Above Product 2"Above Product 2"Above Product 2"Above Product Does turbine shut down when sump sensor detects liquid(both product and ❑ Yes ❑ No © NA L3 Yes ❑ No NA ® Yes ❑ No NA ❑ Yes ❑ dIMNA water T Turbine shutdown response time -------SEE COMMENT BEL -------- Is system programmed for fail-safe ❑ Yes ❑ No 0 NA ❑Yes ❑ No 0 NA ❑ Yes ❑ No 0 NA ❑ Yes ❑shutdown?'Was fail-safe verified to be ❑ Yes ❑ No 0 NA ❑ Yes ❑ No 0 NA ❑Yes ❑ No 0 NA ❑ Yes ❑o erationalT Wait kime between applyingpressurefvacuumiwater and starting 5 minutes 5 minutes5 minotes 5 mintest:Test Start Time: 10:50 AM 10:50 AM 1:25 PM 4:00 Initial Reading(Ri): 0.0025 0.0025 ------ ___-- Test End Time: 11:20 AM 11:20 AM ------ ALOINo Final Reading(RF): 0.0025 0.002 ------ ------ Test Duration: 30 minutes 30 minutes ------Change in Reading(RF-Ri): 0 0 -PasslFail Threshold or Criteria: 1/16"hr. 1/16" hr. T45t ReSuft: D Pass ❑ Fail L7 Pass ❑ Fail p Pass ® Fail Was sensor removed for testing? I� Yes ❑ No ❑ NA 0 Yes ❑ No ❑ NA ❑Yes ❑ No ❑ NA Was sensor properly replaced after 0 Yes ❑ No ❑ NA ® Yes ❑ No ❑ NA ❑ Yes ❑ No ❑ NA testing? Comments- include information on repairs made prior to testing,and recommended follow-up for failed fesfs Turbine Shut Down done during Annual Monitor Certification. Sump 3 has two bad Secondary boots inside 6 over 4 Amerion test boots. Sump 4 failed, don't know why. ' if the entire depth of the sump is not tested,specify how much was tested. if the answer to ay of the questions indicated with an asterisk(*)is"NO" or"NA",the entire sump must be tested. (See S"CB LG-160)