Laserfiche WebLink
Repairs • Clean all bonding surfaces;apply adhesive to both bonding surfaces and to <br /> (continued) the cut edge of the hole. Make sure the cut edge of the hole is well coated <br /> a with adhesive. <br /> Use 1" maximum diameter holesaw <br /> Coat cut edges with adhesive <br /> • Spread the repair piece and center it over the hole. Secure the repair piece <br /> with two hose clamps,3 inches(75 mm)in from each end, and leave clamps <br /> in place. <br /> • All adhesive must be cured before pressurizing the system. <br /> Leave hose clamps in place 3"from each end <br /> • This method of repair has not been investigated by Underwriters' <br /> Laboratories.The responsibility for authorization of use of this method of <br /> repair is that of the inspection authority having jurisdiction. <br /> t <br /> ' Typical installations Dualoy 3000/Lproduct/vapor recovery system <br /> Product and vapor lines should include flexible connectors. However,they are <br /> not required when connecting to properly installed tanks or dispensers due to <br /> the flexible nature of Dualoy 3000/1-pipe.A 4-ft(1200 mm)straight run of <br /> fiberglass pipe is allowable per API 1615. <br /> Dualoy 3000/C piping was used for both primary <br /> and secondary containment lines in this large <br /> fuel handling facility.Seen here is the primary <br /> system during layout. pp <br /> 3 <br /> 14 <br />