Laserfiche WebLink
\J <br /> L��.k�..: 1► �: -.. <br /> JUL 15W6 <br /> 5. UNDER-DISPENSER CONTAINMENT UDC TESTING ` � IT <br /> Test Method Developed By: ❑ UDC Manufacturer ®Industry Standard ❑ Professional Engineer <br /> ❑ Other(Spec) <br /> Test Method Used: ❑Pressure ❑ Vacuum ®Hydrostatic <br /> ❑ Other(Specify) <br /> Test Equipment Used: Incon Sump Tester Equipment Resolution: +/_0.002" <br /> UDC#9/10 UDC#11/12 UDC#13/14 <br /> UDC Manufacturer: Environ Environ Environ <br /> UDC Material: Pol Poly Poi <br /> UDC the 31" 31" 31" <br /> Height from UDC Bottom to Top <br /> of Highest Piping Penetration: 6" 6" 6" <br /> Height from UDC Bottom to <br /> Lowest Electrical Penetration: 4" 4" 4" <br /> Condition of UDC prior to Good Good <br /> testing: Good <br /> Portion of UDC Tested 2"above piping 2"above viving 2"above piping <br /> Does turbine shut down when <br /> UDC sensor detects liquid(both ❑Yes❑No R NA ❑Yes❑No ®NA ❑Yes❑No ®NA <br /> roduct and water)? <br /> Turbine shutdown response time N/A N/A N/A <br /> Is system programmed for fail- <br /> safe shutdown?o ❑yes❑ C1No RNA ❑Yes❑No ®NA Yes❑No ®NA <br /> Was fail-safe verified to be <br /> operational?* [I❑Yes❑No ®NA ❑Yes❑No ®NA Yes[3No ONA <br /> Wait time between applying <br /> Pressure/vacuum/water and 30 minutes 30 minutes 30 minutes <br /> starting test <br /> Test Start Time: g2:25 <br /> WNo <br /> m 2:38 m <br /> Initial Reading(R, : 6318 1.6268 <br /> Test End Time: m m 2:54 proFinal Readin Rr : 1319 1.6251 <br /> Test Duration: n. in. 16 min. <br /> Chane in Readin Rr-Rt): 5001 0.0017 <br /> Pass/Fail Threshold or Criteria: 2" .002" +/_0.002Test Result: ❑F ❑Fail E7 Pass ❑Fail <br /> Was sensor removed for testin ? ❑ No❑NA ®Yeso❑NA <br /> Was sensor properly replaced and ❑ No❑NA ®Yes❑No❑NA <br /> verified functional after testin ? <br /> COMMent9—(include information on repairs made prior to testing, and recommended ollow up for failed tests) <br /> Sensor functionality was not confirmed.This procedure is not part of the Secondary Containment testing scope of work". R <br /> F <br /> If the entire depth of the UDC is not tested,specify how much was tested. If the answer to any of the questions indicated with an <br /> asterisk(*)is"NO"NO"or"NA",the entire UDC must be tested. (See SWRCB LG-160) <br />