Laserfiche WebLink
• <br /> Hydrostatic Sensor Installation Guide Dual-Point Hydrostatic Sensor Installation <br /> 5. Install the cord grip from the Sensor install kit into the field junction box Push the sensor cable into the <br /> junction box through the cord grip.Using the wire nuts from the Sensor install kit, connect the sensor cable <br /> to the console cable as shown in Figure 3.Tighten the cord grip. <br /> 6. Seal wire nuts with epoxy sealant following the instructions in Figure 4. <br /> ® O <br /> CAUTION:Epoxy sealant is irritating to eyes,respiratory system, and skin.Can cause allergic skin reaction. <br /> Contains: epoxy resin and Cycloaliphatic epoxycarboxylate.Precautions:Wear suitable protective clothing, <br /> gloves, eye,and face protection.Use only in well ventilated areas.Wash thoroughly before eating, drinking, <br /> or smoking. <br /> r---------------------------------------------------- <br /> TO <br /> i <br /> Interstitial <br /> Sensor i seal-off From <br /> � Interlace ' ' ' ' Sensor <br /> Module white <br /> i <br /> 1/7'dgid <br /> conduit <br /> Epoxy sealed connections in a <br /> ..�.w..e. weatherproof junction box <br /> _J <br /> Figure 3. Sensor Field Wiring Diagram <br /> AB C From probe, <br /> sensor,or <br /> transducer To console <br /> Make sure that � <br /> the ends of cable <br /> sheathing are sub- i <br /> / merged in sealant Tie wrap <br /> ( �; Wire nuts <br /> Instructions: <br /> NOTE: When temperature is below 50'F (10°C), 4. Mix thoroughly to a uniform color by squeezing <br /> keep resin in a warm place prior to mixing (e.g., contents back and forth 25-30 times. <br /> in an Inside pocket next to body). 5.Squeeze mixed,warn resin into one end of bag <br /> 1. Open epoxy sealant package, and remove resin and cutoff other end. <br /> pak. 6. Slowly insert wiring connections into sealing <br /> 2. Holding resin pak as shown in A,bend pak along pack until they fit snugly against the opposite <br /> long length. end as shown in C. <br /> 3. As shown in B,firmly squeeze the RED SIDE of 7.Twist open end of bag and use tie wrap to close <br /> the resin, forcing it through the center seal and it off and position the tie wrapped end up until <br /> into BLACK SIDE. the resin jells. <br /> Figure 4. Epoxy Sealing Sensor Field Connections <br /> 7. Push the epoxy sealed bag into the junction box Replace and tighten the junction box cover. <br /> 6 <br />