Laserfiche WebLink
�./ Page 6 of 9 <br /> 7. UNDER-DISPENSER CONTAINMENT UDC TESTING <br /> Test Method Developed By: ❑UDC Manufacturer ®Industry Standard ❑Professional Engineer <br /> ❑Other(Specify) <br /> Test Method Used: ❑Pressure ❑Vacuum ®Hydrostatic <br /> ❑Other(Specify) <br /> Test Equipment Used: See attached testing procedures. Equipment Resolution: <br /> UDC#9/10 UDC#11 / 12 UDC# UDC # <br /> UDC Manufacturer: <br /> UDC Material: Fiberglass Fiberglass <br /> UDC Depth: 30" 30" <br /> Height from UDC Bottom to Top 8" 8" <br /> of Highest Piping Penetration: <br /> Height from UDC Bottom to 5" 5" <br /> Lowest Electrical Penetration: <br /> Condition of UDC prior to Fair Fair <br /> testing: <br /> Portion of UDC Tested Above highest Above highest Above highest Above highest <br /> penetration penetrwHon penetration penetration <br /> Does turbine shut down when <br /> UDC sensor detects liquid(both ❑Yes [-]No®NA ❑Yes E]No®NA ❑Yes [:]No®NA E]Yes [:]No®NA <br /> product and water)? <br /> Turbine shutdown response time <br /> Is system programmed for fail- ❑Yes [-]No®NA ❑Yes❑No®NA ❑Yes ❑No®NA ❑Yes ❑No®NA <br /> safe shutdown?* <br /> Was fail-safe verified to be ❑Yes ❑No®NA ❑Yes❑No®NA ❑Yes ❑No®NA ❑Yes ❑No®NA <br /> operational?* <br /> Wait time between applying ' <br /> pressure/vacuum/water and 30 minutes 30 minutes 30 minutes 30 minutes <br /> starting test <br /> Test Start Time: 3:22pm 3:02 m <br /> Initial Reading(R,): 2.6255 1.8103 <br /> Test End Time: 3:37pm 3:17pm <br /> Final Reading(Rr): 2.6263 1.8103 <br /> Test Duration: 15 min 15 min 15 min 15 min <br /> Chane in Reading(R,:-R,): 0.00082 0 <br /> Pass/Fail Threshold or Criteria: 0.002 0.002 0.002 0.002 <br /> Test Result: Pass LJ Fail ® Pass ❑Fail El Pass ElFail ❑ Pass ❑Fail 4 <br /> Was sensor removed for testing? ®Yes❑No❑NA ®Yes❑No ❑NA ®Yes ❑No L]NA ®Yes❑No E]NA <br /> Was sensor properly replaced and <br /> verified functional after testing? <br /> ®Yes❑No E]NA ®Yes❑No❑NA ®Yes❑No❑NA ®Yes❑No El NA <br /> Comments—(include information on repairs made prior to testing, and recommended follow-up forfailed tests) <br /> ' If the entire depth of the UDC is not tested,specify how much was tested. If the answer to any of the questions indicated with an <br /> asterisk(')is"NO"or"NA",the entire UDC must be tested. (See SWRCB LG-160) <br />