Laserfiche WebLink
SWRCB,January 2002 Page 7 of 8 <br /> S. FILL RISER CONTAINMENT SUMP TESTING <br /> Facility is Not Equipped With Fill Riser Containment Sums LK <br /> Fill Riser Containment Sumps are Present,but were Not Tested U <br /> Test Method Developed By: U Sump Manufacturer U Industry Standard U Professional Engineer <br /> U Other(Sped) <br /> Test Method Used: U Pressure U Vacuum U Hydrostatic <br /> U Other(Spec) <br /> Test Equipment Used: Equipment Resolution: <br /> Ful Sump# Fill Sump# Fill Sump# Fill Sump# <br /> Sump Diameter. <br /> Sum the <br /> Height from Tank Top to Top of <br /> Highest Piping Penetration: <br /> Height from Tank Top to Lowest <br /> Electrical Penetration: <br /> Condition of sump prior to <br /> testing: <br /> Portion of Sump Tested <br /> Sump Material: <br /> Wait time between applying <br /> pressure/vacuum/water and <br /> starting test: <br /> Test Start Time: <br /> Initial Reading R,): <br /> Test End Time: <br /> Final Reading(R,): <br /> Test Duration: <br /> Chane in Reading R,Rj): <br /> Pass/Fail Threshold or Criteria: <br /> Test Result: U Pala U Fail U Pass U Fail U Pan U Fail U Pass U Fall <br /> Is there a sensor in the sump? U Yes U No U Yes UNo U Yes UNo U Yes UNo <br /> Does the sensor alarm when UYes UNo UNA <br /> either product or water is UYes UNo UNA UYes UNo UNA UYes UNo UNA <br /> detected? <br /> Was sensor remove i for testing? (Ayes UNo UNA UYes UNo UNA UYes UNo UNA UYes UNo UNA <br /> Was sensor properly replaced and UYes UNo UNA <br /> verified functional after tcstingi UYes UNo UNA UYes UNo UNA UYes UNo UNA <br /> Comments— (include information on rgpairs made prior to testing and recommended follow-up forfailed tests) <br /> No Secondary Containment on fill risers at this site. <br />