INSTALL 1992 - Laserfiche WebLink

Home Browse Search

, Tank Number Tank Tilt Information 1 2 3 4 5 6 7 8 A. Fuel height at fill riser. B. Fuel height at probe riser. i C. Distance between fill and probe riser. D. Distance of probe from center of tank. Note: If A and B are equal, tank tilt equals 0. Table 4-1:Tank Tilt Information. C. Locate the probe input terminal on the bottom C. Using a dip-stick, measure fuel height at the edge of the board and connect probe wiring probe riser and fill riser. Enter the readings on according to color code designations on con- Table 4-1: Tank Tilt Information. IMPOR- troller wiring connection diagram. TANT: If readings are different, a tank tilt is in- 4.2 Probe installation Refer to Installation in- dicated. This information is needed at set-up time. Be sure to take reading before the probe Diagrams on pages 16 and17) is installed. Important: Each probe is identified by its Speed Note: For the most accurate X76 ETM perfor- of Wire and Rep. Rate numbers. These two num- mance, use the center tank opening for the bers must be entered into the controller for (num- probe riser. Any difference in the fuel height at ber of the individual tank) the probe is to monitor. the fill riser and probe riser indicates a tank tilt The Speed of Wire and Rep. Rate are listed on and the following steps should be taken immedi- the permanent label under the probe cap and ately for ease at set-up time. also on the yellow tag attached to the top of the Measure the distance between fill riser and probe. When the probe is installed into the tank, probe riser. as well as the distance from the record the Tank Number and the probe's correct Speed of Wire and Rep. Rate. Check the tank diameter, and fill pipe height to RISER ILL^ C-- RISER PROBE be sure the correct size probe has been ordered and there is clearance from the top of the probe to the fill pipe cap. WARNING:To prevent personal injury, property loss and equipment damage,take necessary precautions to ensure that vehicles do not enter work area. B A A. Measure the distance from the bottom of the TANK tank to the top of the riser pipe. (B). Be sure there is clearance between the top of the - probe and riser pipe cap. See Figure 4-2: Tank Dimensions B. Measure the distance from the bottom of the tank to the bottom of the fill pipe. Add a mini- Tank Dim. "A" Dim. "B" Dim."C" mum of 1" to this distance. Loosen the two set Dia Min. screws on the spacer ring and adjust the dis- 6' 92.62" 95.59" 4.0 Dia. tance from the bottom of the probe. It should be equal to or greater than the distance 8' 116.62" 119.50" 4.0 Dia. measured above. This will ensure that the 10, 140.62" 143.50 4.0 Dia. spacer ring will be located in the probe riser pipe when the probe is installed. Figure 4-2:Tank Dimensions. 6