INSTALL 1992 - Laserfiche WebLink

Home Browse Search

ORTR ENTRY COMMRNOS MOOE 77 78 71F aa© aE PROG. ��a cur asst R N CE IC-771 as ai , i Figure 5-1:Keyboard Functions. probe riser to the center of the tank. Enter this in- 7. Connect a 2-wire cable to the field wire as formation in Table 4-1: Tank Tilt Information on shown in Wiring Diagram, on page 15. page 6. This information will be needed at the Tighten the cable grip in the junction box to in- time of set-up. sure a watertight connection. D. The X76 ETM Probe has been shipped with a NOTE:The 2-wire cable connector has a plug 950 cap adaptor and one loose 3/8"watertight connected under the probe cover. If the probe connector. The probe has a 3 foot 2-wire has to be removed after it is wired in the junction cable for connecting the probe to the junction box, open the 950 cap, remove the four stainless box. Check to make sure this equipment is steel Allen screws, remove the cover (if optional present. probe housing was provided) and disconnect at 1. Screw the 950 adaptor to the pipe riser. the plug. When reconnecting, be sure the gasket between the probe cap and flange is in place. 2. Loosen the watertight cable grip on the 950 fill cap and insert the 2-wire cable. 3. Connect the slack chain attached to the 950 cap to the eye hook on top of the 5.0 KEYBOARD FUNCTIONS probe. IMPORTANT: Check to be sure the wire tie used The X76 ETM System provides you with an al- to secure the fuel and water sensor for shipping phanumeric LCD read-out that will display tank infor- has been removed from the bottom slot of the mation and prompt you through the initial set-up probe housing tube. 5.1 Data Entry Keys NOTE: Check to be sure stick readings have been made and recorded on the tank tilt informa- Provides quick and easy information input. The tion sheet before the probe is installed. This will Clear/Correct key, C/CE, will clear or correct avoid unnecessary delays at set-up time. data entry, and is used for alphabetical input. 4. Insert probe into the riser pipe. Do not let the 5.2 Command Keys probe free fall because this can cause damage to the tank bottom or the probe itself. Enter Key- ENT: Used for data entry. WARNING: Turn off the power to the X76 ETM Tank Number Key-TANK NO.: Used to ad- System before installing probes to prevent vance LCD read-outs to the next tank in your sys- personal injury, property loss and equipment tem. damage. Low Level Key- LO: Used to display the set 5. Adjust the cable lengths between the top of point, in gallons, to the Low Level Alarm for the the probe and the 950 cap so there is more tank number displayed. cable than chain. Then tighten the cable's grip High Level Key- HI: Used to display the set to insure a watertight connection. point, in gallons, of the High Level Alarm for the 6. Insert the watertight cable grip (supplied) into tank number displayed. the junction box and insert the cable from the Display Key- DISPLAY: Used to change the probe through the cable grip into the junction LCD format from inches and gallons to tempera- box. ture and water or time and date. 7