SU0003054 - Laserfiche WebLink

Home Browse Search

SPEC. PRIME CONSTR. CONTRACT - EXHIBIT A June 9, 1995 Pg. 3 of 7 BUELDING MODIFICATION& ADDITION(cont'd) D) A new wall constructed of metal siding and Z bars shall be constructed to separate the dry products mfg. area and the new wet products mfg. area. The intent of the wall is to keep water out of the dry products mfg. area. The wall shall be constructed between two of the four structure legs supporting the silo structure at the south side of the structure and nun west to east. The wall shall extend from floor to ceiling (to the underside of the second floor). Provisions shall be made to silicone seal under the angle iron that secures the siding at the floor to make it water tight. A foam rubber strip will be installed between the siding and the angle iron. The 3° door removed from the warehouse east wall shall be used in the new wall. The metal siding and Z bars removed from the East warehouse wall shall be used for the new wall as material quality and quantity permits; otherwise, materials shall be new and supplied by Contractor. Contractor will provide Z bars, Z bar brackets, sheeting, screws, and flashing. E) An 30" electric motor powered ventilation fan shall be supplied by the Owner and installed in the new wall by contractor as shown in the drawings. F) A beam and two channel supports supplied by the Owner and installed by the Contractor shall be added to the structure of the 1991 building addition at the location of the existing 12' roll up door coming out of the warehouse to help support the new mixer platform. G) A beam and other column supports supplied by the Owner and installed by the Contractor shall be added to the East warehouse wall, where the building siding is to be removed, on the North end, to take the place of the cable cross bracing. The cross bracing must be removed to allow passage of a fork lift to remove dry stucco product from the dry products bagging machine. H) Vertical pipe guards tied into the silo structure support braces shall be added at the location of the old East warehouse wall as shown on G&Z Dwg. No. D-14722. Contractor to supply and install these pipe guards. I) The existing dry stucco bagging machine shall be rotated 90°to face the warehouse building (face West). Modification to the APC dust collection duct shall be made. J) Owner shall supply new handrailing and gates for the second floor to accommodate the addition of the access platform for the new wet products mixer and the new stairway as shown in G&Z Dwg. No. D-14722. The new handrailing and swing gates shall be installed by the Contractor. The Contractor will modify existing handrailing wherever possible as shown in the above referenced drawing. K) The Contractor shall remove the existing stairway from the 1991 addition (the resulting hole at the location where the old stairway was removed, shall be plated over as per G&Z Dwg. No. D-14722) and install a new stairway. Owner shall supply all new materials required for stairway and for the closure of the old stairwell.