COMPLIANCE INFO_2007-2008 - Laserfiche WebLink

Home Browse Search

Suggested specification for UL/ULC Listed Red ThreadO IIA Piping System SECTION 4-instal Ilan and Testing Secon >raty Containment Piping 4.01 Training and Certification. All joints installed or constructed in the field shall be assembled by SECTION I e SQ2129 employees of the contractor who have been trained by This section covers the use of fiberglass reinforced the pipe manufacturer. The pipe manufacturer or their plastic (FRP) pipe for fuel handling and fuel handling authorized representative shall train the contractor's vent and vapor applications including gasoline, employees the proper joining project, and assembling unleaded gasoline, gasoline/alcohol mixtures, b{o- on participation by the contractors employees. Each procedures required for the project, including hands- diesel and diesel that require secondary containment. bonder shall fabricate one pipe-to-pipe and one pipe- to-fitting joint that shall pass the minimum pressure AM=2- General Conditions _ test for the application as stated in Section 2.03 2.01 Coordination. Material furnished and work without leaking. performed under this section shall be coordinated with Only bonders that have successfully completed the related work and equipment specified under other the pressure test shall bond pipe and fittings. Each sections, i.e.Valves, Flexible Connectors, Equipment. bonder shall carry a current manufacturer's proof of training card. 2.Q2 Governing Stand,;t,Lds. Except as mofidifed or 4.02 Pine InsiallOtiQn. Pipe shall be installed as supplemented herein, all materials and construction specified and indicated on the drawings. methods shall comply with and be tested in The piping system shall be installed in accordance accordance with the following standards and test with the manufacturer's current published installation methods: procedures. Standards and Test Methods: 4.03 Testing` A hydrotatic pressure test shall be UL971-2004 Standard for Nonmetallic conducted on the completed piping system. The Underground Piping for Flammable piping system shall be subjected to 10 pressurization Liquids cycles from 0 psig to 1.5 times the design operating ASTM D2310 Standard Classification f o r pressure as stated in Section 2.03.c. After the 10 ac Mhine-Made "Fiberglass" Glass cycles, the pressure shall be held on the system fora 9 Fiber Reinforced Thermosetting minimum of 1 hour and the line inspected for leaks. Test pressures shall not exceed 1.5 times the Resin)Pipe maximum rated pressure of the lowest rated element ASTM D2992 Standard practice for obtaining in the system. Hydrostatic or Pressure Design Basis All pipe joints shall be water tight. All joints that for "Fiberglass" (Glass Fiber Reinf- are found to leak, by observation or during testing, orced Thermosetting Resin) Pipe and shall be replaced by the contractor and retested. Fittings Should hydrostatic testing be impractical, testing 2,03 Operating Conditions. In addition to the with low pressure air or inert gas may be acceptable. , Extreme caution should be used when testing above listed minimum design requirements, the with air. Fallow all safety precautions and testing system shall meet the following minimum operating recommendations of the pipe manufacturer. conditions: a. Operating-Pressure b. Fluid Conveyed c. Test Pressure 2.04 Quality Assurance. Pipe manufacturer's quality program shall be in compliance with ISO 9001 and/or API 01. Pipe and fittings shall be protected from damage L to impact and point loadingPipe shall be properly supported to avoid damage du.e to flexural strain. The contractor shall not allow dirt, debris or other extraneous materials to get into pipe and fittings. All factory machined areas shall be protected from sunlight until installed. F