COMPLIANCE INFO_2007-2008 - Laserfiche WebLink

Home Browse Search

Contractor Instructions November 11, 2007 Page 4 of 6 iota EP1NtzNZEU LEAK iota Final ELD Testing O Scheduling and planning for this test is crucial, make sure you have iota test schedule date as far in advance as possible and communicate any changes immediately — to avoid additional costs make sure you're ready for us by making sure you've completed the items listed on this checklist. With proper preparation, the Final ELD test can usually be performed in one day. Avoid scheduling regulatory inspections or other testing contractors on the same date as your iota final ELD test. O It is the installation contractor's responsibility to properly notify any and all local agencies prior to the scheduled final ELD test. flanks should be ready to receive fuel, backfilled, concrete tank pad poured O Tanks need to be empty of ballast water and/or product O Truck connection dry break and adapter in place. O Vapor extractor fitting should remain in the tank and ball float removed. O All tank openings capped and trimmed. O Installer must be onsite and available to make necessary repairs. O Avoid scheduling regulatory inspections or other testing contractors on the same date as your iota final ELD test. Upper tank fittings and equipment installed and ready to receive fuel O Spill buckets, drop tubes, fill adapters, caps and adapters must be installed and completed. O Tank level probe cap and adapter installed with the tank level probe cord in place from the cord grip on the probe cap to the junction box in the sump. The cover on this junction box should remain open. O Electrical junction boxes for the tank level probe and submersible turbine sump open. O For dry interstitial tanks iota test setups should be installed into tank secondary access ports. Product, vapor and vent piping O Air pressure on all primary and secondary lines (approximately 50 psi on product lines, 5 psi on vent and vapor). O Remove PV valves and cap vent tower risers. O Jumpers between secondary piping at dispensers on flex piping systems should be installed. Ideally, a "T" should be installed into each jumper (see iotaFlexPipe.pdf). ` there is a failure during the final test or at anytime in the future, the "T" will allow for isolation between dispensers to isolate and locate the problem without removing dispensers. 0 Ball valves must be installed at each termination point of the primary piping.