COMPLIANCE INFO_1985-2007 - Laserfiche WebLink

Home Browse Search

-Oct 16 07 07:19p Sheila Wallace 9256897921 p.10 of the pipe bollards, a 12" culvert pipe sleeve may need to be installed before back filling of the UST begins. 2.3.26 All exposed black pipe and fittings and the manway lid in the UST nutine en dose re shall be coated with Hempel, Hempadur 15400 or (2) coats of Sherwin Williams White Epoxy Enamel (Part A # B70 W 211 6405-168111 Part B: # B60 -V-15 630-4430). This coating is to be applied, per specifications and in a professional manner. The galvanized and brass fittings will not be painted 2.3.27 The exterior exposed portion of the tud)ine and lids shall be sanded to a semi - smooth surface and painted with three (3) coats of Rustoleum Professional Spray E , Glossy White, Plid #7592. 2.3.28 Contractor to furnish all required tools specified within the Environ Installafion Specifications and will follow all installation and testing guidelines sed forth in docunicuation. 2.3.29 The Contractor shall provide an EBW Extractor Wrench, PIN 321-100-01 to be stored on site at the completion of the project. 2.3.30 The piping jaint sealant on all black and galvanized piping shall be Loctite 567. No alternate material sealant will] be accepted. 2.3.29 Additional sealant required on the below grade Environ turbine entry boots and other rdated sealed joints shall be Blueline 626 Parasealant, as approval by the California State Water Cmdrod Board (CSWCB). 2.3.32 The Contractor will be required to furnish the following gauges or approved equivalent for testing purposes on the site. Marsh Bellofiam PIN P 11042 ( 4.5 inch, 0 to 30 psi) and PIN P11049 (4.5 inch, 0 to 100 psi) 2.3.33 Any exposed steel aboveground piping shall be painted with two (2) coats of Rustota m enamel pamL Color will be selected during co oar. 2.3.34 Note that all piping and conduit entering into the turbine enclosure must be at right angles to the turbine enclosure surface, without cmepidon. 2.3.35 A piece of the waste portion of the UST turbine shall be cut to 6" wide by 16" long. This curved piece of inverted turbine shall be fiberglassed to the inside of the turbine enclosure, m a location suitable for hanging the 6" by 6" electrical junction box After a suitable location has been deternined, the wall of the enclosure and the inverted strap shall be sanded and fiauty fliberglassed together. Caution should be taken to ensure this junction box Will clear the EBW, PIN 705-475-01 Flex Catch Below Garde Spill Container. 2.3.36 The above ref 6" by 6" electrical junction box shaR be fiberglass with screw mounted, gasketed watertight carver, NEMA 6, Robroy PIN 1-606W. The SCH 80-1"/electrical. PVC undeWmmd conduit from the building shall transition to a 12" steel nipple just before it enters the turbine. An Environ DEB -3100 flexible double entry boot shall be used as the cripple enters the turbine. Once inside the turbine, an explosion lake 90 shall be installed followed by a rigid seal -off and the Robroy box with a Meyers Flub, I" stainless steel or Alunumun STA -3 fitting (3) additional wader tight wire grips will be required for sensorwiring